Robert Juliat Dalis 862S User manual

VALIDATION: 03/05/19
DN41136200
Robert Juliat S.A.S. 32, rue de Beaumont, F 60530 Fresnoy-en-Thelle - phone : [phone] - fax : [phone] - [email protected]
www.robertjuliat.com
DALIS 862S
Firmware V1.XX - 15/11/17
LED 75 W  VARIABLE WHITE FOOTLIGHT
PROJECTEUR BAIN DE PIED LED 75 W  BLANC VARIABLE
FOOTLIGHT
User's manual: Product information page URL:
Package contents:
Download the user's manual and updates from:
www.robertjuliat.com/ambiance_lighting/dalis862
Quick Start Guide
1 x Dalis 862S 1 x Neutrik®powerCON
TRUE1 connector (ref. NACFX-W)

EN
EN - 2 -
GENERAL INSTRUCTIONS
1. Not for residential use.
2. These fixtures must only be serviced by a qualified technician.
3. In addition to the instructions indicated on this page, relevant health and safety requirements of the appropriate EU Directives
must be adhered to at all times.
4. This fixture is in compliance with section 17 - Lighting appliance for theatre stages, television, cinema and photograph studios.
Standards NF EN 60598-1 and NF EN 60598-2-17.
5. This fixture is rated as IP20, and is for indoor use only.
FIXTURE
6. Ensure fixture is correctly mounted on an appropriate support.
7. Protection screens must be replaced in the event of any damage, such as cracks or deep scratches,
since these might reduce performance.
8. WARNING: LED source become hot during use. Allow fixture to cool before servicing.
9. Do not tamper with design of fixture nor any of its safety features.
10. Tighten electrical mains cable connections regularly and replace with one of identical specification if damaged.
11. Use only with correct power supply.
12. Do not orientate the fixture towards a source of light (sun, fixture), in particular for LED versions.
VENTILATION
13. Keep well away from flammable material.
14. Not for outdoor use. Do not cover. Do not permit fixture to get wet.
15. To avoid overheating, do not obstruct air vents.
PLEASE NOTE
These products have been built to conform to European standards relating to professional lighting equipment. Any modification
made to our products will void the manufacturers' warranty.
1 User's instructions
2 Installation
Floor installation only
1. + 2. = -5°
3. + 4. = +5°

EN
EN - 3 -
Power input :
Power output:
Data In:
Data Out:
Ethernet:
4 DMX control
3 Electrical / Data connection
①
②
③
④
⑤
• Connector: Neutrik® powerCON TRUE1
• Voltage: 90 Æ264V 50/60Hz
• Power consumption: 90W max
• Connector: Neutrik powerCON TRUE1
Daisy chain:
•230V: 30 units max
•120V: 15 units max
•100V: 12 units max
• Connector: XLR 5-pin
• Protocol: USITT DMX 512-A / RDM
• Connector: XLR 5-pin
• Protocol: USITT DMX 512-A / RDM
• Connector: RJ45
• Protocol: Art-Net / sACN + software update

EN
DMX
address
Mode 1:
Full4groupsmode16b
Mode 2:
Full1groupmode16b
Mode 3:
Full1groupmode8b
Mode 4:
Presetmode16b
Mode 5:
Presetmode8b
Mode 6:
4groupsindividual16bits
Mode 7:
4groupsindividualpreset16b
1Dimmer Dimmer - Up Stage Dimmer - Up Stage Dimmer Dimmer Dimmer - Up Stage 1 Dimmer - 1
2Dimmer fine Dimmer fine - Up Stage Cool white - Up Stage Dimmer fine Balance Dimmer fine - Up Stage 1 Dimmer fine - 1
3Cool white - Up Stage 1 Cool white - Up Stage Warm white - Up Stage Balance CCT Cool white - Up Stage 1 Balance - 1
4Cool white fine - Up Stage 1 Cool white fine - Up Stage Dimmer - Down Stage CCT S trobe duration Cool white fine - Up Stage 1 CCT - 1
5Warm white - Up Stage 1 Warm white - Up Stage Cool white - Down Stage Strobe duration Strobe speed Warm white - Up Stage 1 Blue position intensity - 1
6Warm white fine - Up Stage 1 Warm white fine - Up Stage Warm white - Down Stage Strobe speed Response time Warm white fine - Up Stage 1 Red position intensity - 1
7Cool white - Up Stage 2 Dimmer - Down Stage Strobe duration Response time Control mode Dimmer - Up Stage 2 Dimmer - 2
8Cool white fine - Up Stage 2 Dimmer fine - Down Stage Strobe speed Control mode Blue position Dimmer fine - Up Stage 2 Dimmer fine - 2
9Warm white - Up Stage 2 Cool white - Down Stage Response time Blue position Red position Cool white - Up Stage 2 Balance - 2
10 Warm white fine - Up Stage 2 Cool white fine - Down Stage Control mode Red position Position Intensity Cool white fine - Up Stage 2 CCT - 2
11 Cool white - Down Stage 1 Warm white - Down Stage Blue position Position Intensity Warm white - Up Stage 2 Blue position intensity - 2
12 Cool white fine - Down Stage 1 Warm white fine - Down Stage Red position Warm white fine - Up Stage 2 Red position intensity - 2
13 Warm white - Down Stage 1 Strobe duration Position Intensity Dimmer - Down Stage 1
14 Warm white fine - Down Stage 1 Strobe speed Dimmer fine - Down Stage 1
15 Cool white - Down Stage 2 Response time Cool white - Down Stage 1
16 Cool white fine - Down Stage 2 Control mode Cool white fine - Down Stage 1
17 Warm white - Down Stage 2 Blue position Warm white - Down Stage 1
18 Warm white fine - Down Stage 2 Red position Warm white fine - Down Stage 1
19 Strobe duration Position Intensity Blue position intensity - 1
20 Strobe speed Red position intensity - 1
21 Response time Dimmer - Down Stage 2
22 Control mode Dimmer fine - Down Stage 2
23 Blue position Cool white - Down Stage 2
24 Red position Cool white fine - Down Stage 2
25 Position Intensity Warm white - Down Stage 2
26 Warm white fine - Down Stage 2
27 Blue position intensity - 2
28 Red position intensity - 2
EN - 4 -
5 DMX chart

DATE D.O.
REP & INDICE DESCRIPTION / AUTEUR OBSERVATIONS VERSION
Table des mises à jour
Section Modifs - 1
INTERNE & CONFIDENTIEL
robert juliat 32, rue de Beaumont F 60530 Fresnoy-en-Thelle phone: [phone] - fax: [phone] - www.robertjuliat.fr
DALIS 862S
DN411362XX
1 ère Lecture & Corrections,
imprimé le 03/05/19
VISA (François J) : .......................................................
Date : .................................................................................
VISA (R & D) : .......................................................
Date : .................................................................................
VISA : .........................................................
Date : .................................................................................
POUR VALIDATION
VISA : ................................................................................
Date : .................................................................................
VISA : ................................................................................
Date : ..................................................................................
VISA : ................................................................................
Date : ..................................................................................
00 15/04/19 SZ/ Création du Quick-Start pour DALIS 864
LL 1e infos transmise par : Séverine le 15/04/19.
00 26/04/19 SZ/ Dessin sur page EN-2 M.A.J. à la demande de Ludwig.
LL Infos transmise par : Séverine le 26/04/19.
V1
V1