Roberts CR9923 User manual

88
92
MHz
540
600
kHz
CR 9923
2 Band Clock Radio
PM
TUNING
FM
MW
ROBERTS
Sound for Generations
CR9923
2 Band Single Alarm
Clock Radio
Please read this manual before use

TIME
SLEEP
ALARM/OFF
Minute Hour
SNOOZE
1
1. Alarm set/off button.
2. Sleep button.
3. Minute button.
4. Hour button.
5. Time set button.
6. Snooze.
Controls (top)
1
23 54
6

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
88
92
MHz
540
600
kHz
CR 9923
2 Band Clock Radio
PM
TUNING
FM
MW
6. Alarm indicator.
7. PM indicator.
8. Tuning control.
6
Controls (front)
2
7 8

9
10
9. Function switch.
10. Dimmer switch.
11. Waveband switch.
12. Volume control.
13. Battery compartment
Controls (left and right side)
3
Low
High
On
Off
Radio
Buzz
DIMMER
MW
FM
VOLUME
11
12
13

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
Switching on
1. Place your clock radio on a flat surface. Plug the power cord into the
wall socket and switch on. The clock display will flash 12.00.
Setting the time
1. Press and hold down the TIME button.
2. Whilst holding down the TIME button press the Hour or Minute
buttons to set the time. Release the buttons when the correct time is
reached. The clock uses a 12 hour display with an PM indicator.
Ensure that the correct 12 hour cycle is selected.
4
88
92
MHz
540
600
kHz
CR 9923
2 Band Clock Radio
PM
TUNING
FM
MW
ON
TIME
Minute Hour
PM

5
Listening to the Radio
1.Switch on the radio by sliding the Function switch to the 'On'
position.
2.Select the required waveband using the Waveband selector
switch.
3. Tune in to the desired station by rotating the Tuning control.
The Wire aerial located on the rear of your clock radio is for FM
reception. The wire should be fully extended and positioned for
optimum reception.
For MW reception there is a built in ferrite aerial. Rotate the your
clock radio to the position giving best reception.
4. Adjust the volume by rotating the Volume control.
5. The radio can be switched off by sliding theFunction switch to the
'Off' position.
On
Off
Radio
Buzz
MW
FM
88
92
MHz
540
600
kHz
TUNING
FM
MW
VOLUME
On
Off
Radio
Buzz

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri) 6
Setting alarm time
1. Press and hold down the ALARM/OFF button.
2. Whilst holding down the ALARM/OFF button press the Hour or
Minute buttons to set the time. Release the buttons when the
correct alarm time is reached. The clock uses a 12 hour display
with a PM indicator. Ensure that the correct 12 hour cycle is
selected.
Checking the alarm time
1. To check alarm time, press and hold down the ALARM/OFF button
the display will show the alarm time.
ALARM/OFF
Minute Hour
PM
ALARM/OFF
PM

7
Setting the alarm to wake to buzzer
1. Set the alarmtime aspreviously described. Set the Function switch
to the 'Buzz' position. The Alarm indicator will light.
The alarm will sound every day at the preset time for 1 hour 59
minutes.Toswitch offthealarm untilthe nextday pressthe ALARM/
OFF button. To turn off the alarm permanently set the Function
switch to the 'Off' position.
Setting the alarm to wake to radio
1. Set the alarmtime aspreviously described. Set the Function switch
to the 'Auto' position. The Alarm indicator will light.
Ensure that the volume is set to the correct level and the desired
station is tuned in.
The alarm will sound every day at the preset time for 1 hour 59
minutes. To turn off the alarm until the next day press the ALARM/
OFF button. To turn off the alarm permanently set the Function
switch to the 'Off' position.
On
Off
Radio
Buzz
PM
On
Off
Radio
Buzz
PM

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri) 8
Snooze control
1. The radio or buzzer alarm can be silenced for 9 minutes by pressing
the SNOOZE button. This sequence can be repeated whilst the
alarm is sounding.
Sleep timer
The radio can be set to turn off after a preset time has elapsed.
1. Press and hold down the SLEEP button.
2. Whilst holding down the SLEEP button set the sleep time using
the Hour and Minute buttons (maximum 1 hour and 59 minutes in
1 minute steps).
The radio will switch off after the sleep time has elapsed.
3. To cancel the sleep function before the preset time has expired,
press the SNOOZE button.
SNOOZE
SLEEP
PM
SNOOZE

9
Dimmer Switch
The DIMMER switch located on the left side of your clock radio will
allow you to adjust the intensity of the clock display to suit room
brightness.
Low
High
DIMMER
Specifications
Power Requirements
Mains : AC 230 volts, 50Hz only
Back-up Battery : IEC size 6LR61 (6F22, PP3)
Frequency Coverage
FM 87.5 - 108MHz
MW 525 - 1610kHz
Circuit Features
Loudspeaker 8 ohms
Output power 250mW
Aerial System FM Wire Aerial
MW Built-in Ferrite aerial
ROBERTS RADIO LIMITED
PO BOX 130
MEXBOROUGH
SOUTH YORKSHIRE
S64 8YT
The Company reserves the right to amend the specification without notice.