Robot Factory 3DLPrinter Instruction Manual

3DLPrinter
3DLPrinter-HD
Technical Note 01/14
Manual installation of the USB device
May 26, 2014

Pag. 2 di 8
Follow CAREFULLY these steps
Make sure you have followed the instructions for driver installation and
firmware update program, referring to page 5 of the manual "Printer3DLP
- Installation and use of the program."
Connect the power cord, press the power switch at the back of the printer, plug the printer's USB cable
into a free socket of the PC, press, on front of the printer, the start button for a few seconds (until it
shows the message in the display).
If in operating system does not appear the window of the automatic recognition of a new device, proceed
with manual configuration.
Press the Start button and move on item Computer
With the right mouse button open the selection window and choose “Properties”.

Pag. 3 di 8
In the window that appears select “Device Manager”
In the "Device Manager" window identify the "Unknown device".

Pag. 4 di 8
With the right mouse button open the selection window and choose “Update Driver Software”.
From the window that appears select Browse my computer for driver software

Pag. 5 di 8
Press the Browse button
Select the folder C:\3DLP\Drivers and press the OK button.
Press the Next button

Pag. 6 di 8
If the Windows Security appears, select Install this driver software anyway
At the end of the installation, press the Close button

Pag. 7 di 8
In the Device Manager window, you can see the proper installation of device.
If you are using Windows 8, for installation refer to the following link:
https://learn.sparkfun.com/tutorials/disabling-driver-signature-on-windows-8/all

Pag. 8 di 8
In order to improve and grow the product, we ask that you inform us of any possible malfunction or
improvements, sending an email to [email protected] with the much detail as possible description
about the problem when it occurs or the required improvement.
A. Martini
Robot Factory S.r.l. - Via Caltana, 59 - 30035 Mirano VE
Tel - Fax:[phone] Mobile:[phone] - P.IVA: 03654900277
www.robotfactory.it - [email protected]
Robot Factory S.r.l. reserves the right to make changes in specifications, materials and accessories without notice. No
warranty is provided beyond that attached to the product. Robot Factory S.r.l. assumes no liability for any incidental or
consequential, foreseeable or not, caused by misuse of its products.