RODE Microphones Wireless PRO User manual

CAMERA SETUP GUIDELINES | SONY ZV-E10
AND

Before you start
This walkthrough will help you ensure optimal
compatibility between your Wireless PRO or Wireless GO
II system and your camera, to ensure your audio
recordings are clear and clean.
You should connect your receiver to your computer, start
the RØDE Central app, and select the preset for the
SONY ZV-E10 to ensure the settings on your microphone
match those for your camera.
If you do not have access to RØDE Central, make sure
you manually set the gain on your receiver to -6dB using
the ‘dB’ button on the receiver.
CAMERA SETUP GUIDELINES | SONY ZV-E10
Important information
While these settings have been designed to work well in
most situations, you should always check your levels
manually using the meters on your camera. If you are
recording unusually loud or quiet sounds, you may need
to adjust the recording level of your camera up or down
to get an optimal result.
NOTE: When using the Wireless GO II in very loud situations or with
Interview GO handheld adapter, we recommend activating the PAD
function in RØDE Central. (The advanced gain functionality in the
Wireless PRO means that a PAD is not required.)

CAMERA SETUP GUIDELINES | SONY ZV-E10
STEP 1
Make sure ZV-E10 is set to Movie Mode. Press
Camera/Movie/S&Q button at the top of the
camera (under on/off switch). Press button until
you are in Movie Mode.

CAMERA SETUP GUIDELINES | SONY ZV-E10
STEP 2
Press MENU button, on back of camera on the
upper-right.

CAMERA SETUP GUIDELINES | SONY ZV-E10
STEP 3
Scroll to CAMERA 2 symbol, at the top. Then
press DOWN on the control wheel to navigate
the menu.

CAMERA SETUP GUIDELINES | SONY ZV-E10
STEP 4
Scroll to page 3/9, then scroll down to and
select 'Audio Rec Level'

CAMERA SETUP GUIDELINES | SONY ZV-E10
STEP 5
Adjust the audio recording level down to '1'.
Then press Select to confirm.

CAMERA SETUP GUIDELINES | SONY ZV-E10
YOU’RE READY TO GO!
Your camera is now set up and ready to go.
Happy filming!