ROGERSELLER Flow 123004 Installation guide

Technical Overview
Dimensions are approximate. Information in this technical overview is representative of the product available at the time of printing.
Duetoour policy of continuous product development, the design and speciications depicted are subject to change without notice.
Pleaseconirm allparticulars with your sales consultant prior to purchase.
Flow
Please note
• Seal all wall penetrations with a neutral cure silicone.
• This is only a technical overview. Rogerseller recommends having
theproductonsite before commencing rough in.
Flow Hand Shower On Rail
with Wall Union
123004— Chrome
10 inishes available
Ø39.4
Ø24 Ø127
155
574
87.3

rogerseller.com.au
Rogerseller Showrooms —
Melbourne
173177 Barkly Avenue
Burnley VIC 3121
P 03 9429 8888
Sydney
18 Danks Street
Waterloo NSW 2017
P 02 8396 8700
Brisbane
7476 McLachlan Street
Fortitude Valley QLD 4006
P 07 3251 4333
Perth
153 Broadway
Nedlands WA 6909
P 08 6389 1366
Concept Stores —
Southern Innovations
(Fishwick ACT)
P 02 6143 2666
Southern Innovations
(Mitchell ACT)
P 02 6129 7666
Southern Innovations
(Albury NSW)
P 02 6022 2777
Routleys Plumbing Innovations
(Malvern SA)
P 08 8291 3000
Specifications
It is a requirement of State Plumbing Codes that licensed plumbers carry out all tapware installations.
Allinstallations should comply with the relevant requirements of AS/NZS 3500 and local plumbing codes.
Pressure:
[1] Maximum Hydrostatic Pressure: 1000kpa. This pressure may be exceeded only under test conditions as per
AS/NZS 3500. Where hydrostatic pressure exceeds the maximum stated above, pressure-limiting valves should
be installed. [2] Recommended Maximum Hydrostatic Pressure: 500kpa (AS/NZS 3500)
[3] Recommended Minimum Hydrostatic Pressure: 150kpa
Temperature:
Maximum Water Temperature: 80° C. For optimum performance, hot and cold inlet water pressure should
beequal.
Care and Maintenance
[1] Product should be inspected for surface damage prior to installation. [2] Cleaning and handling of all
inishes must be performed carefully. [3] Clean products using a soft cloth with warm soapy water only. [4]
Never use harsh detergents or abrasive cleaners as these will damage the product. [5] Water marks can be
removed from Matt Finishes with an application of a carnauba wax based non-abrasive polish on a microibre
cloth. [6] Do not use undue pressure when cleaning and wipe in one direction only. [7] Contact with harsh
chemicals such as hair dye, hair bleach etc with result in damage to the inish. [8] Tapware should never
be installed using acetone silicones. [9] Avoid the use of wax based furniture creams as this can result in a
build up of deposits which will detract from the appearance. [11] Damage to inishes arising from improper
installation or post installation use or failure to observe the above care and cleaning instructions will void all
warranty agreements.
Warranty
Rogerseller tapware, bathroom ittings and sanitary ware are covered by a ive (5) year warranty from date
ofpurchase. Forfullterms and conditions please refer to rogerseller.com.au