RoMedic FlexiMove User manual

Manual: 00805En Ver. 1 090129
FlexiMove is used in different transfer and repositioning situations such as turning in bed, repositioning higher up in bed,
bed to bed/bed to shower trolley, and lifting from the floor. FlexiMove features either four or six handles. The choice
depends on the patient’s need for support and required number of caregivers.
FlexiMove is part of a series of different models of transfer assistive devices. The choice of model and material is deter-
mined by the patient’s functional capacity and the situations in which the product is to be used.
RoMedic’s products together form the SystemRoMedic concept, which takes a holistic approach to patient transfers.
SystemRoMedic has four categories of transfers: transfer, positioning, support and lifting.
Visual inspection
Check the condition and function of the product regularly, and always after laundering. Check to ensure that the fabric is
not worn, damaged or bleached. If there are signs of wear, the product must be discarded.
Read instructions for all assistive devices used in connection with transfers.
To prevent discomfort, exercise care and caution when using the product.
Functional inspection
Always read the instructions
Manual
152x53
112x53
Max:150 kg/330 lbs
102x43

Ver.1 090129
Functional testing of FlexiMove
Test the FlexiMove regularly by stepping on one handle and pulling hard on one of the
handles on the opposite side. Repeat the procedure until all of the handles have been
tested.
Placement of FlexiMove
The patient is turned on one side and the FlexiMove is guided in with the handles folded
under the slide. The patient is then turned on the back and the handles are drawn out.
Place FlexiMove as described above. Then, use the handles to pull the patient closer to
the edge of the bed. Work in a walking stance with knees slightly bent, straight arms and
straight back (1).
Fold in the handles, and then turn the patient in the opposite direction, where one care-
giver provides support. If you are working alone, raise the bed rails. Turn the patient using
the legs and pushing the patient away from you (2).
Turning in bed
2
MANUAL
1
2

Ver.1 090129
Higher up in bed
One caregiver works on either side of the bed. Repositioning is easier if the patient is
able to bend his or her knees to push higher up in bed. Work in a walking stance with
straight arms and straight back. Caregivers should coordinate their efforts to perform a
smooth transfer.
Bed to bed/bed to shower trolley
Caregivers should work in pairs (or more), depending on the patient’s needs. Place
beds as close together as possible. Pull the feet over first, and then help each other to
manoeuvre the patient over to the bed/shower trolley.
Lifting from the floor
Caregivers should work in pairs (or more), depending on the patient’s needs. Plan the
transfer so as to minimize time taken, lifting and distance.
NOTE!
A mechanical lift should always be used, if possible. When lifting manually, never lift more than is appropriate.
3
MANUAL

Size::
4011 102 x 43
4012 112 x 53
4016 152 x 53
Material:
Polyamide, nylon
Cleaning: Remove the slide and padding and then clean surfaces with disin-
fectant. Launder the cover according to the symbols on the tag.
Care of the product:
Read the product label.
Do not use rinsing agent. To en-
sure maximum material life, hang
dry or tumble dry on low heat.
When in doubt, contact your RoMedic representative for product trials, advice or information.
If you require additional information, contact your transfer specialist or our representative, or visit www.romedic.com. Make
sure you always have the most recent version of the manual. Manuals are available for downloading from our website;
http://www.romedic.com
RoMedic AB
Box 640 Tel: [phone] Internet: www.romedic.com
SE-175 27 Järfälla Fax:[phone] E-mail: [email protected]
SWEDEN