Romer AgraStrip Mycotoxin WATEX User manual

AgraStrip®Mycotoxin WATEX Test Kits include:
•24 test strips
•24 extraction buffer bags
•24 conjugate microwells
•1 bottle of 30 mL assay dilution buffer
•48 yellow/white pipette tips
•24 blue pipette tips
•24 microcentrifuge tubes (dilution tubes)
•24 Whirl-Pak®Bags with Filter
•1 tube holder
•1 SD card
Also Available:
•AgraStrip®Mycotoxin
•AgraQuant®Mycotoxin
•Starline™ IAC
•MycoSpin™
•MycoSep®& MultiSep®
•Biopure™ Reference Material
AgraStrip®Mycotoxin WATEX Quick Guide

The AgraStrip®WATEX
methods for Total

are USDA-GIPSA approved
®Quantitative Test WATEX
  
AgraStrip®  
Quantitative Test WATEX
AgraStrip®  
Quantitative Test WATEX
AgraStrip®  
Quantitative Test WATEX
AgraStrip®  
Quantitative Test WATEX
WATEX
One for All
WATER EXTRACTION
USDA/GIPSA
APPROVED
TEST KIT
SYSTEM

AgraStrip®Mycotoxin WATEX Quick Guide
Result Interpretation
A color line always appears in the upper
section of the test strip to indicate that
the test strip is working properly. This line
is the control line.
Invalid results:
If there is no control line in the control
zone, the test is invalid and the sample
should be re-tested by using a valid test
strip.
Valid results:
2 lines are visible. The intensity of the line
in the test zone is indirectly proportional
to the mycotoxin concentration and has to
be measured with the AgraVision™.
Add 30 ml of distilled
water to the Filter
Whirl-Pak®Bag.
Weigh-in 10 g of ad-
equately ground, rep-
resentative sample
and add one Extrac-
tion Buffer Bag into
one side of a Filter
Whirl-Pak®Bag.
Preheat AgraStrip®
Incubator for about
30 minutes until

Shake vigorously for
2 minutes.
Put a test strip into
each well, close the
AgraStrip®Incuba-
tor lid and allow
the strip to develop
color for 3 minutes.
Wipe strip onto an
absorbent paper
and immediately
read with
AgraVision™ reader.
Let sample settle for
2 minutes.

assay dilution buffer
in a dilution tube.*
Put microwell into
the AgraStrip®
Incubator and add
100 µL diluted
sample extract.
Mix the content by
pipetting it up and
down 10 times.
Read the Package Insert instructions completely before performing any test.


extract and transfer
into the dilution tube.
 7 8 9 10
Procedure of AgraStrip®Mycotoxin WATEX on corn
*May differ depending on kit type and application. Please refer to the respective application brief
4321

!"#TFE
!$%& · Tulln, Austria · TFE
!#!# · Singapore · TFE

'''#(#
!&)&$