ROSE DISPLAYS ANOFRAME ROUND WITH 2 WALL MOUNTS User manual

Parts
35 Congress Street, Salem MA 01970
Tel# [phone] Fax# [phone]
e-mail:[e-mail]
split rails
solid rail
Figure 2
Instructions For Hanging
Round Profile Instruction Sheet
AnoFrame™
Figure 1
Figure 3
Figure 5
Figure 4
Step 1
Locate the two split rails and the
solid rail that is the same length as
the split rails.
Insert corner brackets into side
AnoFrame rails. Insert two corner
brackets into each end of the solid
side Ano rail. Insert one corner
bracket into each end of each split
side Ano rail. Fig. 1 & Fig. 2
Note: Tension tabs on corner
brackets face towards outside of
frame.
Step 2
Finish assembling frame by follow-
ing sequence in Fig. 3.
Step 3
Install wall mounting hangers using
a Phillips head screwdriver. A
plastic expansion anchor is sug-
gested for drywall installations.
Fig. 4
Step 4
Slide AnoFrame onto wall mount-
ing hangers. Fig 5. Insert poster.
Note: The AnoFrame shown here
is a round profile. It is available
in either square or round profile.
solid rail
solid rail
split rails
Incept-8.15.02
The AnoFrame is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoFrameWallHangers
Wall Mounting
Hangers
06-6067
AnoFrame Rails
12AF-100
AnoFrame
Split Rails
Corner
Brackets

Parts
split rails
solid rail
Figure 2
Instructions For Hanging
Round Profile Instruction Sheet
AnoFrame™
Incept-8.15.02
The AnoFrame is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoFrameWallHangers
Wall Mounting
Hangers
06-6067
AnoFrame Rails
12AF-100
AnoFrame
Split Rails
Corner
Brackets
Figure 1
Figure 3
Figure 5
Figure 4
Step 1
Locate the two split rails and the
solid rail that is the same length as
the split rails.
Insert corner brackets into side
AnoFrame rails. Insert two corner
brackets into each end of the solid
side Ano rail. Insert one corner
bracket into each end of each split
side Ano rail. Fig. 1 & Fig. 2
Note: Tension tabs on corner
brackets face towards outside of
frame.
Step 2
Finish assembling frame by following
sequence in Fig. 3.
Step 3
Install wall mounting hangers using
a Phillips head screwdriver. A plastic
expansion anchor is suggested for
drywall installations.
Fig. 4
Step 4
Slide AnoFrame onto wall mounting
hangers. Fig 5. Insert poster.
Note: The AnoFrame shown here
is a round profile. It is available in
either square or round profile.
solid rail
solid rail
split rails