ROSE DISPLAYS ANOFRAME SQUARE WITH CABLE CLIP AND BALL... User manual

Parts
Step 1
Insert corner brackets into vertical AnoFrame
sides. Fig. 1 & Fig. 2. Note: Assembly
brackets tension tabs face towards outside of
frames. Split rail side is made up of 2 separate
pieces.
Step 2
Insert single ball of ball chain into inner
channel of Cable Clip. The cable should snap
into place. Fig. 3
Step 3
Align one round end of cable clip with top
channel of the aluminum rail and insert. Once
in place, insert end of ball chain into channel.
Then press down on the other round end of the
cable clip and slide into rail by pushing on the
clip. Fig. 4 Repeat steps 2 & 3 for second cable
clip.
Note: Be sure to push on the cable clip in
order to slide the ball chain into place. Do
not pull on, or push against, the ball chain as
this will cause it to bind in the channel.
Step 4
Assemble frame following steps in. Fig. 5
sliding sides together in the order shown.
Step 5
Insert poster. Fig 6.
AnoFrame
TM
Instructions for assembly
Incept-9.24.02
The AnoFrame™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoFrameCableClipBallChain
Instruction Sheet
Figure 1
Figure 3 Figure 4
Figure 5
Figure 2
solid rail w/
solid rail
split rails
34
split rails
solid rail
2
1
Figure 6
35 Congress Street, Salem, MA 01970
Tel# [phone] Fax# [phone]
e-mail:[e-mail]
Corner
brackets
Cable Clips
06-5050
AnoFrame rails
12AF100
AnoFrame
split rails
Ball Chains
96-0302P

Parts
Step 1
Insert corner brackets into vertical
AnoFrame sides. Fig. 1 & Fig. 2. Note:
Assembly brackets tension tabs face to-
wards outside of frames. Split rail side is
made up of 2 separate pieces.
Step 2
Insert single ball of ball chain into inner
channel of Cable Clip. The cable should
snap into place. Fig. 3
Step 3
Align one round end of cable clip with top
channel of the aluminum rail and insert.
Once in place, insert end of ball chain into
channel. Then press down on the other
round end of the cable clip and slide into rail
by pushing on the clip. Fig. 4 Repeat steps 2
& 3 for second cable clip.
Note: Be sure to slide the ball chain into
place by pushing on the cable clip. Do not
pull on, or push against, the ball chain as
this will cause it to bind in the channel.
Step 4
Assemble frame following steps in. Fig. 5
sliding sides together in the order shown.
Step 5
Insert poster. Fig 6.
AnoFrame
TM
Instructions for assembly
Incept-9.24.02
The AnoFrame™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoFrameCableClipBallChain
Corner
brackets
Cable Clips
06-5050
AnoFrame rails
12AF100
AnoFrame
split rails
Instruction Sheet
Figure 1
Figure 3 Figure 4
Figure 5
Figure 2
solid rail w/
solid rail
split rails
34
split rails
solid rail
2
1
Figure 6
Ball Chains
96-0302P