Rosewill RT-CY687B User manual

Company: Remote Tech LLC
Address: 310 ALDER RD, Dover, DE 19904, USA
Name: Remote Key
Model: RT-CY687B
Operation instructions
1. After matching the key to the car, press 1 the unlock key for 2 seconds to open the
door and press 2 the lock key for 2 seconds to close the door.
2. The ignition key is used to manually unlock and start the car.
Product parameters
Rated voltage
DC 3V
Working current
<12mA
Operating voltage
DC 3.3V-2.2V
Transmit power
>-8dbm
Key operation force
200±50g
Operating temperature
-5°C +45°C
Stand-by current
＜7uA
transmitting frequency
433.92MHZ±75KHZ
Modulation
ASK
Battery
CR2032
Key durability
More than 70,000 times
2key:Unlock
1 key:lock key
3key:Trunk
5 key: Panic
警报键
4 key: RS
启动键

FCC warning statements:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.

IC warning statements:
-English Warning Statement:
RSS-GEN ISSUE 5, 8.4 User manual notice
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B).
-French Warning Statement:
RSS - Gen version 5, 8.4 avis du manuel de l'utilisateur
Cet appareil contient un émetteur / récepteur sans licence conforme au RSS sans licence
d'innovation, science et développement économique Canada.L'opération doit satisfaire
aux deux conditions suivantes:
Cet équipement peut ne pas causer d'interférence.
L'équipement doit accepter toute interférence, y compris toute interférence qui pourrait
entraîner un fonctionnement indésirable de l'équipement.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This
equipment has very low levels of RF energy that are deemed to comply without testing of
specifc absorption ratio (SAR).Cet équipement est conforme aux limites d’exposition aux
rayonnements énoncées pour un environnement non contrôléet respecte les règles
d’exposition aux fréquences radioélectriques (RF) CNR-102 de l’IC. Cet équipement émet
une énergie RF très faible qui est considérée conforme sans évaluation du débit
d’absorption spécifque (DAS).