Russell Hobbs 19006 User manual

instructions
£10,000 prize draw
EXTRA year guarantee
FREE rewards gallery
www.productregister.co.uk/rhobbs
Register online now!
See back for
details

2

3
Read the instructions, keep them safe, pass them on if you pass the
appliance on. Remove all packaging before use.
AIMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1 This appliance can be used by persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been supervised/instructed and
understand the hazards involved.
•Keep the appliance and cable out of reach of
children; they must not use or play with it.
sTo avoid injury, take care handling the blades,
emptying the jug, and cleaning.
uDon’t add hot liquid (over 40°C), as it may be
ejected due to sudden steaming.
cMisuse of the appliance may cause injury.
2 Don’t leave it unattended while plugged in.
3 Unplug before assembling, dismantling or
cleaning.
4 If the cable is damaged, return the appliance,
to avoid hazard.
LDon’t put the motor unit in liquid.
5 Don’t use the blender unless the lid and cap are fitted.
6 Don’t put utensils into the jug while the appliance is plugged in.
7 Switch off (0) before fitting the jug to the motor unit.
8 Switch off (0), and wait till the blades stop before removing the
lid from the jug, or removing the jug from the motor unit.

4
9 Don’t use accessories or attachments other than those we supply.
10 Don’t use the appliance for any purpose other than those
described in these instructions.
11 Don’t operate the appliance if it’s damaged or malfunctions.
12 You may use the processor and disc for cutting/grating for up to
2 minutes. Any other use should be restricted to 1½ minutes.
After this, let the motor rest for 2 minutes.
household use only
CIN BRIEF
1 Sit the motor unit on a dry, firm, level surface.
2 Route the cable so it doesn’t overhang, and won’t trip or catch.
3 Lower the jug on to the motor unit, then turn the jug clockwise,
to lock it in place.
4 Remove the lid.
5 Put the ingredients into the jug – don’t fill past the max mark.
6 Put the lid on the jug.
CPOWER UP
7 Check that the speed control is set to 0.
8 Put the plug into the power socket (switch it on, if it’s switchable).
CSPEED CONTROL
9 Turn the speed control clockwise (1 = low, 2 = high).
10 Turn it back to 0 to turn the motor off.
11 Use low speed (1) for lighter applications, using mainly liquid
ingredients, and high speed (2) for heavier applications, using
mainly solid ingredients.
12 Turning it anti-clockwise to Ywill give you a short burst at high
speed, for more precise control. In this direction, the control is
spring-loaded. When you let go, it’ll return to 0.
NUSING THE BLENDER
13 Lower the jug on to the motor unit, then turn the jug clockwise,
to lock it in place.
14 Pull the lid up and off the jug – it’s stiff, because of the seal.
15 Put the ingredients into the jug – don’t fill past the max mark.
16 Put the lid on the jug, and push it down to seal it.

5
17 Align the pips on the cap with the slots in the hole, fit the cap in
the hole, and turn clockwise.
,Don’t run the blender without the cap.
18 To add ingredients while the motor is running:
a) turn the cap clockwise to unlock it, and lift it off
b) add the ingredients via the hole
c) replace the cap, and turn it anti-clockwise to lock it
19 Turn the jug anti-clockwise to unlock, and lift it off the motor unit.
NCRUSHING ICE
20 Start with half to threequarters of a cup of ice, or 4 to 6 cubes,
and add 15ml (1 tbsp) of water.
21 Put the lid on the blender, then turn the speed control to Yfor a
second or so, check the state of the ice, and repeat till the ice is
the consistency that you need
NCARE AND MAINTENANCE
22 Switch off (0) and unplug before cleaning.
23 Wipe the outside of the motor unit with a clean damp cloth.
24 Handwash the removable parts.
` You may wash these parts in a dishwasher.
25 If you use a dishwasher, the harsh environment inside the
dishwasher will affect the surface finishes.
26 The damage should be cosmetic only, and should not affect the
operation of the appliance.
NBLADE UNIT
27 You may remove the blade unit for cleaning.
28 This is best done with the jug upside down.
29 Grip the jug handle with one hand.
30 Grip the bottom of the blade unit with the other hand.
31 Turn the blade unit clockwise till it comes loose from the jug base.
32 Carefully, pull it up and out of the bottom of the jug.
33 Wash the seal and blade unit in warm soapy water, rinse, and air
dry.
34 Take great care with the blades – don’t handle them directly, use
a nylon washing-up brush.
35 Replace the seal round the blade unit.

6
36 Turn the blade unit upside down, and replace it in the bottom of
the jug base.
37 Turn the blade unit anti-clockwise to tighten it.
PRECIPES
coriander pesto (dip, topping or sauce)
4 handfuls fresh leaf coriander
4 cloves fresh garlic
120g pine nuts
250ml olive oil
120g freshly grated Parmesan
salt and pepper
Put the coriander, garlic, pine nuts, and a bit more than half the oil
into the jug. Fit the lid, and process at moderate speed till it looks
smooth. To adjust the thickness, add a little oil, give it a short burst,
and repeat till it’s right. Transfer to a bowl, stir in the Parmesan, taste,
and adjust the seasoning. Serve as a dip (fairly thick), as a topping
for soup (not too thick, but not runny), or tossed through warm
pasta (fairly runny).
recipes are available on our website:
blender – http://www.russellhobbs.com/ifu/550931
smoothies – http://www.russellhobbs.com/ifu/550941

7
OUSING THE PROCESSOR
38 Unplug the appliance.
39 Fit the spindle to the top of the motor unit.
40 Lower the jug on to the motor unit, then turn the jug clockwise,
to lock it in place.
41 Choose the attachment you need.
OWITH THE SUPPORT
42 Use the chopper for pulverizing ingredients.
43 Use the mixer to mix ingredients together.
44 Use the creamer to thicken cream, to beat eggs, and to cream
eggs and sugar together.
45 Fit the attachment over the support, and slide it to the bottom.
46 Lower the support into the centre of the jug, over the spindle.
47 Put the ingredients into the jug – don’t fill it past the max mark.
48 Hold the lid with the tube slightly behind the jug handle, set it on
the jug, then turn it clockwise, to lock the tab into the top of the
handle.
49 To add ingredients while the motor is running:
a) lift the pushed out of the tube
b) add the ingredients via the tube
c) replace the pusher
50 To remove the lid, turn it anti-clockwise to unlock, then lift it off.
OWITH THE DISC
51 Fit the slicer or one of the graters into the disc.
52 Lower the disc over the top of the spindle.
53 Hold the lid with the tube slightly behind the jug handle, set it on
the jug, then turn it clockwise, to lock the tab into the top of the
handle.
54 Remove the pusher, and drop the ingredients down the tube.
55 Replace the pusher, and use it to push the ingredients gently
down the tube.
,Don’t use fingers or cutlery to push food down the tube – only
the pusher.
56 The blade(s) on top of the disc will slice or grate the food into the
bowl.

8
57 Don’t let the bowl get more than about half full – stop and empty
it.
58 To remove the lid, turn it anti-clockwise to unlock, then lift it off.
59 Turn the disc over, and press one of the metal ends in and down,
to remove the slicer/grater.
OCARE AND MAINTENANCE
60 Switch off (0) and unplug before cleaning.
61 Wipe the outside of the motor unit with a clean damp cloth.
62 Handwash the removable parts.
` You may wash these parts in a dishwasher.
63 If you use a dishwasher, the harsh environment inside the
dishwasher will affect the surface finishes.
64 The damage should be cosmetic only, and should not affect the
operation of the appliance.
QRECIPES
quick cheese & tomato pizzas (2 medium pizzas)
2 sachets active dried yeast
2 tsp sugar
240ml lukewarm water
440g strong white flour
2 tbsp olive oil
1 tsp salt
1x300g jar pizza sauce
200g mozzarella cheese
Mix the water, yeast, and sugar in a bowl, and leave it for 5 minutes.
Fit the mixer. Process the flour and salt at low speed. Add the water,
yeast, and sugar mixture via the tube. Add the oil, and process at
high speed till a dough ball forms, then reduce speed. Run for 20
seconds, and rest for 2 minutes. Do this twice more, then let the
dough rest for 10 minutes.
Divide the dough into 2 balls, and stretch or roll each ball to fit a
lightly oiled baking tray. Top with the pizza sauce. Use the coarse
grater to grate the mozzarella cheese. Spread the cheese over the
pizzas and add other toppings if desired. Bake in a pre-heated oven
at 190°C/gas mark 5 for 15-20 minutes.

9
recipes are available on our website:
http://www.russellhobbs.com/ifu/551078

10