Ryvyr INDUS 2 Series User manual

INDUS 2
TM
INSTALLATION INSTRUCTIONS
VANITY STAND
V-INDUS2-24DW | V-INDUS2-30DW
V-INDUS2-36DW | V-INDUS2-48DW
SUGGESTED TOOLS AND MATERIALS
Phillips Screwdriver Level Drill Tape Measure Safety Glasses
10'
ROUGHING-IN
21.5" (546mm)
10.75" (273mm)
X” (ymm)
33.9" (862mm)
3.9" (100mm)
0.8" (20mm)
5.5" (140mm)
6.5" (165mm)
V-INDUS2-24DW 24” 610mm
V-INDUS2-30DW 30” 762mm
V-INDUS2-36DW 36” 914mm
V-INDUS2-48DW 48” 1219mm
Model # X
THANK YOU FOR CHOOSING RYVYR
Please take a few minutes to review this manual before you start installation. If you encounter
any installation problems, please don’t hesitate to contact us. Before you begin, please
observe all local building codes. Unpack the new product and inspect for damage. The
appearance of your vanity may differ from the illustrations in this guide. These instructions
still apply. Please ensure the finished wall is straight and plumb and the floor is flat and
perpendicular to the finished wall.
12.2015
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax [phone] any time
FLOOR
FINISHED
WALL
Y

CARE AND CLEANING OF VANITY
Dust the vanity frequently with a clean, soft, dry, lint-free cloth, as well as polish it on a regular basis. Clean the surface by
rubbing in the direction of the grain. Avoid using silicone cleaners and waxes.
Clean up excess water and spills immediately. Use blotting rather than a wiping action. Water left over a long period of
time will cause white spots in the finish. Please note that some chemicals may damage the finish.
• Position the vanity against the finished wall. If necessary, turn the leg levelers to achieve level.
•The vanity legs are removable per your installation needs.
• Mark the supply and drain locations on the inside of the vanity back wall.
• Move the vanity away from the wall and cut the marked supply and drain locations from inside.
• Position the vanity against the wall, aligning the supply and drain locations with the cut holes.
• Install the countertop, sink, drain and faucet according to the manufacturer’s instructions.
INSTALLATION INSTRUCTIONS
VANITY TOP / UNDERMOUNT
SINK APPLICATION
* Shown with Extension Legs Installed
VESSEL SINK APPLICATION
* Shown with Extension Legs Removed
4” Extension Legs
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax [phone] any time
12.2015