Ryvyr KARA V-KARA-30DE User manual

10.2014
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax [phone] any time
INSTALLATION INSTRUCTIONS
KARA
VANITY
V-KARA-30DE | V-KARA-36DE
TM
SUGGESTED TOOLS AND MATERIALS
Phillips Screwdriver Level Drill Tape Measure Safety Glasses
10'
THANK YOU FOR CHOOSING RYVYR
Please take a few minutes to review this manual before you start installation. If you encounter
any installation problems, please don’t hesitate to contact us. Before you begin, please
observe all local building codes. Unpack the new product and inspect for damage. The
appearance of your vanity may differ from the illustrations in this guide. These instructions
still apply. Please ensure the finished wall is straight and plumb and the floor is flat and
perpendicular to the finished wall.
ROUGH-IN DIMENSIONS
FLOOR
FINISHED
WALL
21” [533mm]
4” [100mm]
9 3/8” [238mm]
9 1/2” [240mm]
34” [864mm]
48" [1220mm]
10” [254mm]
6” [152mm]
10” [254mm]

10.2014
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax [phone] any time
A
B
1.
2.
WALL
Secure the vanity to the wall
• To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading. Also avoid extreme
changes in temperature by arranging furniture away from radiators, heat and air vents, and air conditioning units. Avoid placing
furniture directly under windows. Damage caused by any of the afore mentioned will void the warranty.
• Clean the furniture frequently with a clean, soft, dry, lint-free cloth. Clean the surface by gently rubbing in the direction of the grain.
Avoid using silicone cleaners and waxes.
• Clean up excess water and spills immediately. Use blotting rather than a wiping action. Water left over a long period of time will
cause white spots in the finish and the furniture to possibly warp. Please note that some chemicals may damage the finish.
Standing water and the use of strong chemicals will void the warranty.
CARE AND CLEANING
• Position the vanity against the finished wall. If necessary, turn the leg levelers to achieve level.
• Mark the supply and drain locations on the inside of the vanity back wall.
• Move the vanity away from the wall and cut the marked supply and drain locations from inside.
• Position the vanity against the wall, aligning the supply and drain locations with the cut holes.
• Install the counter top, sink, drain and faucet according to the manufacturer’s instructions.
INSTALLATION INSTRUCTIONS