Ryvyr V-BAMBU-30DB User manual

INSTALLATION INSTRUCTIONS
VANITY
V-BAMBU-30DB | V-BAMBU-36DB
SUGGESTED TOOLS AND MATERIALS
Phillips Screwdriver Level Drill Tape Measure Safety Glasses
10'
THANK YOU FOR CHOOSING RYVYR
Please take a few minutes to review this manual before you start installation. If you
encounter any installation problems, please don’t hesitate to contact us. Before you
begin, please observe all local building codes. Unpack the new product and inspect
for damage. Please ensure the finished wall is straight and plumb and the floor is flat
and perpendicular to the finished wall.
ROUGH-IN DIMENSIONS
FLOOR
FINISHED
WALL
BAMBUTM
x" [y mm]
24" [610mm]
21 1/2" [546mm]
WALL-MOUNT
BRACKET
Model # Width
V-BAMBU-30DE x = 30" y= [762mm]
V-BAMBU-36DE x = 36" y= [914mm]
Consider the thickness of
the sink top, or vessel top
with vessel, when
determining the height to
install your vanity.
Common finished height to
top, used on floor mounted
vanities, is 34”.
02.2017
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 ET or fax [phone] any time
A divsion of ELK Group International

WALL PREPARATION
Position of Bracket
2 x 6
Brace
Notch studs 1-1/2” [38mm]
to provide support for brace
REMOVE WOOD SUPPORTS
Remove wood supports from the back of vanity
02.2017
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 ET or fax [phone] any time

• Position the vanity against the finished wall.
• With the screws provided, mount the mounting brackets onto the 2 x 6 brace.
INSTALLATION INSTRUCTIONS
CARE AND CLEANING
• To maintain the beauty of the finish, avoid placing the furniture in direct
sunlight, as sunlight causes fading. Also avoid extreme changes in temperature
by arranging furniture away from radiators, heat and air vents, and air
conditioning units. Avoid placing furniture directly under windows.
• Dust the vanity frequently with a clean, soft, dry, lint-free cloth, as well as polish
it on a regular basis. Clean the surface by rubbing in the direction of the grain.
Avoid using silicone cleaners and waxes.
• Clean up excess water and spills immediately. Use blotting rather than a wiping
motion. Water left over a long period of time will cause white spots in the finish
Please note that some chemicals may damage the finish.
• Installation requires 2 people.
02.2017
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 ET or fax [phone] any time

SIDE
CAM HEIGHT
TILT
ADJUSTMENT
1
21
2
02.2017
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 ET or fax [phone] any time