Ryvyr SELLA V-SELLA-60MXX User manual

INSTALLATION INSTRUCTIONS
VANITY
V-SELLA-60MXX| V-SELLA-80MXX
SUGGESTED TOOLS AND MATERIALS
Phillips Screwdriver Level Drill Tape Measure Safety Glasses
10'
THANK YOU FOR CHOOSING RYVYR
Please take a few minutes to review this manual before you start installation. If you
encounter any installation problems, please don’t hesitate to contact us. Before you
begin, please observe all local building codes. Unpack the new product and inspect
for damage. Please ensure the finished wall is straight and plumb and the floor is flat
and perpendicular to the finished wall.
ROUGH-IN DIMENSIONS
10.2014
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax [phone] any time
FLOOR
FINISHED
WALL
SELLATM
SUGGESTED HEIGHT:
Undermount Application:
13.25” (336.6mm)
Vessel Application:
7.25” (184mm)
Model # Width
V-SELLA-M60XX x = 23.6" y= [600mm]
V-SELLA-M80XX x = 31.5" y= [800mm]
x [y]
20.67" [525mm]
17.7" [450mm]
WALL-MOUNTED
BRACKET
(CONTRACTOR INSTALLED)
WALL-HANGING
BRACKET SYSTEM
6.8" [173mm]
13.7" [348mm]
PRE-MOUNTED
TO VANITY

10.2014
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax [phone] any time
WALL PREPARATION
Position of Bracket
2 x 6
Brace
Notch studs 1-1/2” [38mm]
to provide support for brace
WALL BRACKET ISTALLATION
Position of Brackets
2 x 6
Brace
UNLOCK X 2
UNLOCK
WALL
BRACKET
• With the screws provided, mount the mounting brackets onto the 2 x 6 brace.

10.2014
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax [phone] any time
WALL PREPARATION
* Pre-installed
on vanity
(left and right)
UNLOCK
Wall Bracket
Pre-Installed Clip
WALL BRACKET ADJUSTMENT
• Position the vanity against the finished wall.
• Installation requires 2 people.
•Insert vanity clip intothe outside rectangular slot and allow it to drop down
until it is seated securely in the wall bracket.
22mm
19mm

10.2014
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax [phone] any time
SIDE
CAM HEIGHT TILT
DRAWER ADJUSTMENT INSTRUCTIONS
1
21
2
CARE AND CLEANING
• To maintain the beauty of the finish, avoid placing the furniture in direct
sunlight, as sunlight causes fading. Also avoid extreme changes in temperature
by arranging furniture away from radiators, heat and air vents, and air
conditioning units. Avoid placing furniture directly under windows.
• Dust the vanity frequently with a clean, soft, dry, lint-free cloth, as well as polish
it on a regular basis. Clean the surface by rubbing in the direction of the grain.
Avoid using silicone cleaners and waxes.
• Clean up excess water and spills immediately. Use blotting rather than a wiping
motion. Water left over a long period of time will cause white spots in the finish
Please note that some chemicals may damage the finish.