Ryvyr WAVE User manual

INSTALLATION INSTRUCTIONS
WAVE
VANITY
V-WAVE-24DK
TM
SUGGESTED TOOLS AND MATERIALS
Phillips Screwdriver Level Drill Tape Measure Safety Glasses
10'
THANK YOU FOR CHOOSING RYVYR
Please take a few minutes to review this manual before you start installation. If you encounter
any installation problems, please don’t hesitate to contact us. Before you begin, please
observe all local building codes. Unpack the new product and inspect for damage. The
appearance of your vanity may differ from the illustrations in this guide. These instructions
still apply. Please ensure the finished wall is straight and plumb and the floor is flat and
perpendicular to the finished wall.
ROUGH-IN DIMENSIONS
24" [610.0mm]
34" [864mm]
16" [406.1mm]
30" [762mm]
21-1/2" [546.0mm]
4” [101.6mm] 3" [76.0mm]
8" [204.0mm]
A divsion of ELK Group International
02.2017
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 ET or fax [phone] any time

• Position the vanity against the finished wall. If necessary, turn the leg levelers to achieve level.
• Mark the supply and drain locations on the inside of the vanity back wall.
• Move the vanity away from the wall and cut the marked supply and drain locations from inside.
• Position the vanity against the wall, aligning the supply and drain locations with the cut holes.
• Install the countertop, sink, drain and faucet according to the manufacturer’s instructions.
INSTALLATION INSTRUCTIONS
• To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading. Also avoid extreme
changes in temperature by arranging furniture away from radiators, heat and air vents, and air conditioning units. Avoid placing
furniture directly under windows.
• Dust the vanity frequently with a clean, soft, dry, lint-free cloth, as well as polish it on a regular basis. Clean the surface by rubbing
in the direction of the grain. Avoid using silicone cleaners and waxes.
• Clean up excess water and spills immediately. Use blotting rather than a wiping action. Water left over a long period of time will
cause white spots in the finish. Please note that some chemicals may damage the finish.
CARE AND CLEANING
**NOTE: items shown are
Ryvyr recommended
components and are
not included.
Mark & cut supply hole
locations on wall
Position vanity
against wall
Install sink, faucet,
& countertop
according to
manufacturer’s
instructions
02.2017
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 ET or fax [phone] any time