Saab 400 106 662 User manual
6DDE
9-5Monteringsanvisning
SCdefault
0217(5,1*6$19,61,1*Â,167$//$7,21,16758&7,216
0217$*($1/(,781*Â,167$//$7,216'(0217$*(
SITdefault
6DDE
5DGLRLQVWDOODWLRQNLW
1 Radio compartment
2 Storage compartment
3 Adapter assembly
4Plasticframe
5 Fitting instructions 47 12 204
Accessories Part No. Group Date Instruction Part No. Replaces
$XJ -XQ
E930A031
2
43
1
2 4712204
6DDE
1 Remove the cover panel on the dashboard.
2 Snip the cable tie securing the cable with
connector and aerial cable. Pull the cables
through the hole.
3Connect the adapter assembly to the car’s
wiring harness and wind anti-squeak tape round
the connectors.
4 Connect the adapter assembly and aerial cable
to the radio and secure the aerial cable to the
adapter assembly with a cable tie as close as
possible to the adapter assembly’s connection
to the radio.
5 Unplug the adapter assembly and aerial cable
from the radio and tighten the cable tie
additionally. Cut off the cable tie.
6 Pass the cables (including the aerial cable)
through the radio compartment (do not press the
compartment into place).
7 Secure the adapter assembly as close as
possible to its connection to the car’s wiring
harness and round the upper part of the radio
compartment at the rear. Pass a cable tie
through the opening in the black connector
where the adapter assembly’s grey connector is
connected and round the upper part of the radio
compartment at the rear. Tighten the cable tie
and cut off the end.
8 Slide the radio compartment into the dashboard
while checking the car’s wiring harness to make
sure that it is not pinched or kinked.
At the rear of the radio compartment is a locating
stud which should fit into a cut-out in the heating
and ventilation unit.
9 Fit the plastic frame on the radio.
10 Plug the connector and aerial cable into the
radio. Slide the radio into the compartment while
carefully pulling the adapter assembly up into
the upper part of the radio compartment where
the storage compartment is to be fitted. Make
sure that the aerial cable is not pinched or
kinked. The radio should be pushed in so far
that its catches engage properly with the radio
compartment.
11 Fit the storage compartment.
7RUHPRYHWKHUDGLR
a Pull out the storage compartment.
b Dismantle the radio using the tools supplied with
it and extract it from the radio compartment,
passing the adapter assembly down from the
upper part of the radio compartment at the same
time.
c Carefully unplug the connectors from the radio.
E367A014
31
2
11
7
9
4
Other Saab Automobile Accessories manuals
