Saab B205 User manual

Saab 9-5 B205, B235
9-5Installation instructions
SCdefault
MONTERINGSANVISNING ·INSTALLATION INSTRUCTIONS
MONTAGEANLEITUNG ·INSTRUCTIONS DE MONTAGE
SITdefault
Saab 9-5 B205, B235
Parking heater
1 Extension cable
2 Connector plug and connector cable
3 Holder
4 Screw (x2) -M05
5Screw
6Starwasher
7 Heating element
8 Locking clip
9 Cable tie (x5)
10 Clips
11 Screw (x2) M06-
12 Nut (x2) M06-
Accessories Part No. Group Date Instruction Part No. Replaces
32 025 650
32 026 240 9:87-31 Oct 07 53 29 271 53 29 271 Sep 05
E930A39
3
3
4
1
2
86
5
79
10
12
11

2 5329271
Saab 9-5 B205, B235
1 Read fully through the installation instructions
and check that all the parts are present in the kit.
2 Lay covers on the wings and remove the cap on
the coolant system expansions tank.
3 Raise the car. Use a receptacle to collect the
coolant. Remove the air shield behind the
bumper, connect a hose, open the drain plug
and drain the coolant.
4 Lower the car to a suitable working height for fit-
ting the connector plug to the bumper shell.
WARNING
Take care if the engine is hot. The coolant will also
be hot. You could get burnt if you brushagainstthe
exhaust manifold.
E930A260
2
3

5329271 3
Saab 9-5 B205, B235
5-M05: Mark out the location for the holder for the
supply connector plug. The arrow on the holder
should point forwards. Make holes with a brad-
awl.
6 -M05: Place the supply connector plug in the
holder so that the cover opens upwards. Fit the
holder to the bumper.
Proceed to step 12.
E930A261
5
5
6

4 5329271
Saab 9-5 B205, B235
7M06-: Tape the spoiler using woven tape for
example to prevent damage to the paintwork.
8M06-: Mark out the location for the holder for the
supply connector plug using a bradawl on the
rib, see illustration. The arrow on the holder
should point forwards.
9M06-: Drill two 6 mm holes in the rib. Bend the
rib down using a hammer handle for example in
order to facilitate access. Fitaplastic hose to the
drill to prevent damage to the paintwork.
10 M06-: Position the supply connector plug in the
holder and secure it with screw and nut. The
cover must open towards the number plate.
11 M06-: Remove the tape.
9 9 10
7
E930A395

5329271 5
Saab 9-5 B205, B235
12 Raise the car and close the drain plug.
13 Insert the supply connector cable between the
radiator and the subframe. Locate the cable
connection on top of the gearbox.
14 Drill a 3.5 mm diameter hole for the ground
cable in the underside of the left-hand structural
member.
15 Scrape off any paint to ensure a good ground
connection and secure the ground cable with a
screw and lock washer (place the lock washer
between the ground cable terminal and the
body). Apply light anti-corrosion agent, part no.
30 15 971. Secure the ground cable along the
supply cable.
16 Fit the air shield and lower the car.
E930A394
13
14