SAFAVIEH COUTURE Jamie KNT4108B User manual

NOTICE
*Please make sure that you have all parts indicated and they are in good condition before you
begin assembly of this item. Refer to part list and hardware list below for guidance.
*This item should be assembled on a soft surface to prevent scratching the finish during
assembly.
*This item may require periodic tightening.
* If you are having difficulty, our friendly Customer Care team is always here to help. Please
email [email protected] Model# KNT4108
Product Dimensions: 33.3” W*62.8” D*38.5” H
* Before beginning assembly of product, make sure all parts are present. Compare parts with
part contents list and hardware contents list.
*If any part is missing or damaged, do not attempt to assemble the product.
*Estimated assembly Time: 5 minutes.
CARE AND MAINTENANCE
Spot clean using a mild water-free solvent. Only a professional cleaner should undertake
a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
PIECE DESCRIPTION PICTURE QUANTITY
A Seat 1x
B Front leg set 2x WARNING
C Back leg set 2x Weight Capacity-550LBS
HW1
Plastic Washer
(attached on the legs)
4x Warning:Do not stand on chaise
Warning:Do not over torque bolts
PREPARATION
Parts List and Hardware List

* Before beginning assembly of product, make sure all parts are present. Compare parts with
part contents list and hardware contents list.
*If any part is missing or damaged, do not attempt to assemble the product.
*Estimated assembly Time: 5 minutes.
* If you are having difficulty, our friendly Customer Care team is always here to help. Please
email [email protected]
STEP4: TURN THE CHAISE UPRIGHT AND MAKE SURE ALL
LEGS ARE LEVEL. THEN FULLY TIGHTEN ALL LEGS. THIS ITEM
MAY REQUIRE PERIODIC TIGHTENING. ASSEMBLY IS NOW
COMPLETE
STEP3: SCREW THE REAR LEGS (C) THROUGH THE
PLASTIC WASHER (HW1) INTO SEAT (A) BUT DON'T
TIGHTEN COMPLETELY.
PREPARATION
STEP1: CAREFULLY TURN THE SEAT (A) ONTO ITS SIDE, ON A
SMOOTH SCRATCH FREE SURFACE. TAKE OUTTHE LEGS AND
HARDWARE.
STEP2: SCREW THE FRONT LEGS (B) THROUGH THE
PLASTIC WASHER (HW1) INTO SEAT (A) BUT DON'T
TIGHTEN COMPLETELY.