Safavieh Furniture Arjun SEA8013 User manual

PIECE QUANTITY
A 1X
B 1X
Model # SEA8013
Product Dimensions : 18.1"W x 23.2"D x 40.1"H
Back Rest
Front leg-1
DESCRIPTION
PICTURE
Seat
CARE AND MAINTENANCE
Spot clean using a mild water-free solvent. Only a professional cleaner should
undertake a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
NOTICE
* Please make sure that you have all parts indicated before you begin assembly of this
item
* This item should be assembled on a soft surface to prevent scratching the finish
during assembly
* This item may require periodic tightening
Part List and Hardware List
E1 E2
A
B
A
E1
D
C
E1 E2
E3
E2 E1
E2
E3
F
E1
E2
E3
B 1X
C 1X
D 1X
E1 6X
E2 6X Weight Capacity: 300 lbs
E3 1X
WARNING: DO NOT STAND ON CHAIR
WARNING: DO NOT OVER TORQUE BOLTS/SCREWS
Spanner
F
Black Fabric
The legs and hardware are located underneath the chair in the
zipper compartment.
1X
Bolt 8 X 60 mm
Flat Washer
Back Rest
Front leg-1
Front leg-2
E1 E2
A
B
A
E1
D
C
E1 E2
E3
E2 E1
E2
E3
F
E1
E2
E3
The legs and hardware are located underneath the chair in the
zipper compartment.

Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
Tools Required for Assembly (included): Spanner
STEP1 TAKE OUT LEGS AND HARDWARE WHICH PLACED
ON THE UNDERSIDE OF THE SEAT
STEP2 PUT THE WASHERS ON THE BOLT IN THE ORDER
SHOWN IN THE PICTURE
STEP3 INSERT THE FRONT LEGS AND SCREW IN THE BOLTS
BUT DON'T TIGHTEN COMPLETELY
PREPARATION
E1
E2
A
E1
D
C
E1
E2
E3
E2
E1
E2
E3
The legs and hardware are located underneath the chair in the
zipper compartment.
STEP4 INSERT THE BACK LEGS AND SCREW IN THE BOLTS
BUT DON'T TIGHTEN COMPLETELY
STEP5 PUT THE CHAIR UPRIGHT AND MAKE SURE ALL LEGS
ARE LEVEL, THEN FIRMLY TIGHTEN BOLTS WITH SPANNER
WHILE THE CHAIR IS UPRIGHT AS PICTURED ABOVE
STEP6 FIX THE BLACK FABRIC ON THE UNDERSIDE OF THE
SEAT, THIS ITEM MAY REQUIRE PERIODIC TIGHTENING
STEP1 TAKE OUT LEGS AND HARDWARE WHICH PLACED
ON THE UNDERSIDE OF THE SEAT
STEP2 PUT THE WASHERS ON THE BOLT IN THE ORDER
SHOWN IN THE PICTURE
STEP3 INSERT THE FRONT LEGS AND SCREW IN THE BOLTS
BUT DON'T TIGHTEN COMPLETELY
A
B
F
E1
E2
E3
The legs and hardware are located underneath the chair in the
zipper compartment.