Safavieh Furniture Bronn ACH9502A User manual

Page1:
CARE AND MAINTENANCE
Spot clean using a mild water-free solvent.Only a professional cleaner should undertake
a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
F U R N I T U R E
NOTICE
*Please make sure that you have all parts indicated before you begin assambly of this
*This item should be assambled on a soft surface to prevent scratching the finish during
assembly Item# ACH9502A
*This item may require periodic tightening Product Dimensions:24.4"W X 34.05"D X 32.28"H
Part List
PIECE DESCRIPTION PICTURE QUANTITY
A Back 1X
B Seat 1X
C Seat Rail 1X
Weight Capacity:275lbs
WARNING:DO NOT STAND ON CHAIR

Page2:
D Left arm 1X
E Right arm 1X
Hardware
PIECE DESCRIPTION PICTURE QUANTITY
① Bolt (M8*60MM) 8X
② Bolt (M8*70MM) 4X
③ Spring Washer 12X
④ Washer 12X
⑤ Allen Key 1X

Page3:
PREPARATION
Before beginning assembly of product,make sure all parts are present.Compare parts with package contents list
If any parts is missing or damage,do not attempt to assemble the product.
Estimated Assembly Time:20 Minutes.
1
Step1:
Step2:
Put the Back(A) onto the Seat(B)
Position the Left(D) on the assembled Back(A) and Seat(B)
as shown in the picture.
as shown in the picture.
Attach Back(A) to Seat(B) by using Bolts(①),
Attach Left leg(D) to Back(A) by using Bolts(②),
Spring Washers(③) and Washers(④) with Allen Key(⑤).
Spring Washers(③) and Washers(④) with Allen Key(⑤).
Friendly notice:
Friendly notice:
If the mounting positions cannot be aligned well
If the mounting positions cannot be aligned well
and hinder the installation, then sway the Back(A) lightly
and hinder the installation, then sway the Leg(D) lightly
when locking the Bolts, this action could help prevent the
when locking the Bolts, this action could help prevent the
Bolts from getting stuck and ensure smooth assembly.
Bolts from getting stuck and ensure smooth assembly.
Do not fully tighten the Bolts.
Do not fully tighten the Bolts.
②
③
⑤
B
A
D
B
④
④
③
①
1
⑤
2
A

Page4:
3
Step3:
Turn the assambled parts over as the photo.
Then put the Right leg(E) onto the Back(A) and Seat（B)
Attach them as step1 to step2.
Put the Seat Rail(C) between the Left leg(D) and Right leg(E)
Attach the Left leg(D) and Right Leg(E) to Seat rail(C) using Bolts(①),
Spring Washers(③) and Washers(④) with Allen Key(⑤).
Finally,tighten the Bolts fully in a sequential manner.
B
A
D
E
3
④
③
①
C