Safavieh COUTURE SFV4700 User manual

CARE AND MAINTENANCE
NOTICE
HW2 Flat Washer(M8) 12X
BFront Leg 2X
HW1 Split Lock Washer(M8) 12X
CBack Leg 2X
Part List and Hardware List
PIECE DESCRIPTION PICTURE QUANTITY
SAFAVIEH
HW3 Socket Screws 8*1.25*30MM 12X
HW4 Allen Key 1X
ASeat 1X
Spot clean using a mild water-free solvent. Only a professional cleaner should
undertake a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or
staining.
* Please make sure that you have all parts indicated before you begin assembly of
this item
* This item should be assembled on a soft surface to prevent scratching the finish
during assembly
* This item may require periodic tightening SFV4700
Dimensions:32.09"WX30.31"DX31.5"H
Weight Capacity: 275 lbs
C O U T U R E
WARNING: DO NOT STAND ON CHAIR
WARNING: DO NOT OVER TORQUE BOLTS/SCREWS
The legs and hardware are located in the carton.

PREPARATION
The legs and hardware are located underneath the chair in the zipper compartment.
STEP5 PUT THE CHAIR UPRIGHT AND MAKE SURE ALL
LEGS ARE LEVEL, THEN FIRMLY TIGHTEN BOLTS WITH
ALLEN KEY WHILE THE CHAIR IS UPRIGHT AS
PICTURED ABOVE(IF THE CHAIR WOBBLY, YOU CAN
EASY ADJUST LEG BOTTOM PLASTIC SCREW)
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list.
If any partismissing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
Tools Required for Assembly (included): Allen key
STEP1 OPEN THE ZIPPER ON THE UNDERSIDE OFTHE
SEAT AND TAKE OUT LEGS AND HARDWARE STEP2 PUT THE WASHERS ON THE SCREW IN
THE ORDER SHOWN IN THE PICTURE
STEP3 INSERT THE LEGS AND SCREW IN THE
SCREWS BUT DON'T TIGHTEN COMPLETELY.REPEAT
THE SAME STEPS FOR THE OTHER THREE LEGS
STEP4 CLOSE THE ZIPPER ON THE UNDERSIDE
OFTHE SEAT.
HW2 HW1 HW3
A
C C
B
B
HW1
HW4 B/C
HW2
HW3
PREARATION
A