Salda RIRS EKO 3.0 1200 VEL Guide

RIRS 12005500 V EKO 3.0 RHX
EN MOUNTING AND INSTALLATION INSTRUCTION

2 | EN RIRS 1200-5500 V EKO 3.0 v2020.1
1. CONTENT
2.SYMBOLS AND MARKING 3
3.SAFETY INSTRUCTIONS AND PRECAUTIONS 5
4.INFORMATION ABOUT THE PRODUCT 6
4.1. DESCRIPTION 6
4.2. DIMENSIONS AND WEIGHT 6
4.3. TECHNICAL DATA 9
4.4. OPERATING CONDITIONS 10
4.5.STANDART PACKAGE OF COMPONENTS 10
4.6. DESCRIPTION OF COMPONENTS 10
5. INSTALATION 11
5.1. RECEPTION OF GOODS 11
5.2. TRANSPORTATION AND STORAGE 11
5.3. UNPACKING 12
5.4.PIPING AND INSTRUMENTATION DIAGRAM 13
5.5. MOUNTING 14
5.5.1.UNIT PLACING AND MOUNTING POSITIONING REQUIREMENTS 14
5.5.2. FLOOR MOUNTING 14
5.6. CONNECTION OF THE AIR DUCT 14
5.7.CONNECTION OF THE UNIT TO ELECTRIC NETWORK 15
5.8. START-UP RECOMMENDATIONS 15
5.8.1. SYSTEM PROTECTION 15
5.8.2.PRE-STARTUP RECOMENDATIONS OF THE UNIT (IN THE PRESENCE OF THE ENDUSER) 15
6. MAINTENANCE 16
6.1. SAFETY INSTRUCTION 16
6.2.GENERAL RECOMMENDATIONS FOR VENTILATION SYSTEM MAINTENANCE 16
6.3. COVER OPENING 16
6.4. FILTERS 17
6.5. ROTOR MAINTENANCE 17
6.6. FANS MAINTENANCE 17
6.7. HEATER MAINTENANCE 18
6.8. CONTROL BOARD MAINTENANCE 18
7. CONTROL 19
7.1. DEVICE CONTROL 19
7.2. DEVICE FUNCTIONS 19
8. ACCESSORIES 20
8.1. CONNECTION OF ACCESSORIES 24
8.1.1.FIRE PROTECTION SIGNAL INPUT (FIRE PROTECTION INPUT (NC)) 24
8.1.2.EXTERNAL CO2/PRESSURE SENSORS 24
8.1.3.ROOM CO2 TRANSMITTER INSTALLATION RECOMMENDATION 24
8.1.4.CO2 CONCENTRATION ACCORDING TO PETTENKOFER LIMIT 25
8.1.5.CONNECTION OF SUPPLY AND EXTRACT AIR DAMPERS 25
8.1.6.CONNECTION OF REMOTE CONTROL PANEL OR MODBUS 26
8.1.7.WATER HEATER CIRCULATION PUMP AND VALVE ACTUATOR 26
8.1.8.RECOMMENDED SCHEME FOR CONNECTION OF INTERNAL AND EXTERNAL COMPONENTS 27
9.POSSIBLE FAULTS AND TROUBLESHOOTING 37
10.ECODESIGN DATA TABLE 38
11.DECLARATION OF CONFIMITY 40
12. WARRANTY 41
12.1. LIMITED WARRANTY COUPON 41

EN | 3RIRS 1200-5500 V EKO 3.0 v2020.1
2. SYMBOLS AND MARKING
Warning – pay attention Additional information
Apply the auxiliary label on the unit (on an easily accessible location) or on the dashed location of the technical manual in order to keep the
important information about the unit.
Figure. 2.1. Technical label
1 - Logo; 2 - Product code (SKU); 3 - Product name; 4 - Technical data; 5 - Serial number; 6 - Production place.
Figure. 2.2. Indication for duct connection.
ODA - outdoor air; SUP - supply air; ETA - extract air; EHA - exhaust air.
Figure. 2.3. Technical label place and air duct indication RIRS 1200-
1900 V EKO 3.0 (right version)
Figure. 2.4. Technical label place and air duct indication RIRS 1200-
1900 V EKO 3.0 (left version)
Figure. 2.5. Technical label place and air duct indication RIRS 2500-
3500 V EKO 3.0 (right version)
Figure. 2.6. Technical label place and air duct indication RIRS 2500-
3500 V EKO 3.0 (left version)

4 | EN RIRS 1200-5500 V EKO 3.0 v2020.1
Figure. 2.7. Technical label place and air duct indication RIRS 5500
V EKO 3.0 (right version)
Figure. 2.8. Technical label place and air duct indication RIRS 5500
V EKO 3.0 (left version)
NOTE. Ducts are not the part of the unit.

EN | 5RIRS 1200-5500 V EKO 3.0 v2020.1
3. SAFETY INSTRUCTIONS AND PRECAUTIONS
Read these instructions very carefully before installing and using this equipment. Installation, connection and maintenance should be carried out
E\DTXDOL¿HGWHFKQLFLDQDQGLQDFFRUGDQFHZLWKWKHORFDOUHJXODWLRQVDQGOHJLVODWLRQ
7KHFRPSDQ\VKDOOWDNHQRUHVSRQVLELOLW\IRUWKHLQMXULHVRUGDPDJHGSURSHUW\LIWKHVDIHW\UHTXLUHPHQWVDUHQRWIROORZHGRUWKHGHYLFHLVPRGL¿HG
ZLWKRXWWKHSHUPLVVLRQRIWKHPDQXIDFWXUHU
Main safety rules
Danger
• %HIRUHFDUU\LQJRXWDQ\HOHFWULFDORUPDLQWHQDQFHZRUNVPDNHVXUHWKDWWKHGHYLFHLVGLVFRQQHFWHGIURPWKHPDLQVDQGDOOPRYLQJSDUWV
of the device have stopped.
• Make sure that the fans are not accessible through air ducts or branch openings.
• If any liquids on electric parts or connections that bear voltage are noticed, stop the operation of the device.
• 'RQRWSOXJWKHGHYLFHLQWRWKHPDLQVWKDWGLႇHUIURPWKHRQHLQGLFDWHGRQWKHODEHORURQWKHKRXVLQJ
• 9ROWDJHRIWKHPDLQVVKRXOGFRPSO\ZLWKWKHHOHFWURWHFKQLFDOSDUDPHWHUVLQGLFDWHGRQWKHODEHO
• 7KHGHYLFHVKRXOGEHHDUWKHGLQDFFRUGDQFHZLWKWKHUHJXODWLRQVRQWKHLQVWDOODWLRQRIHOHFWULFGHYLFHV7XUQLQJRQDQGXVLQJXQHDUWKHG
GHYLFHLVQRWDOORZHG)ROORZWKHUHTXLUHPHQWVVSHFL¿HGRQWKHGHYLFH¶VODEHOVWKDWLQGLFDWHGDQJHU
Warnings
• &RQQHFWLRQRIHOHFWULFLW\DQGPDLQWHQDQFHRIWKHGHYLFHVKRXOGEHSHUIRUPHGE\WKHTXDOL¿HGSHUVRQQHORQO\DQGLQDFFRUGDQFHZLWK
WKHPDQXIDFWXUHU¶VLQVWUXFWLRQVDQGVDIHW\UHTXLUHPHQWV
• ,QRUGHUWRUHGXFHWKHULVNGXULQJLQVWDOODWLRQDQGPDLQWHQDQFHVXLWDEOHSURWHFWLYHFORWKLQJPXVWEHZRUQ
• %HZDUHRIVKDUSDQJOHVZKLOHFDUU\LQJRXWLQVWDOODWLRQDQGPDLQWHQDQFHZRUNV
• 'RQRWWRXFKKHDWLQJHOHPHQWVXQWLOWKH\KDYHQ¶WFRROHGGRZQ
• 6RPHGHYLFHVDUHKHDY\\RXVKRXOGEHYHU\FDUHIXOZKLOHWUDQVSRUWLQJDQGLQVWDOOLQJWKHP8VHVXLWDEOHOLIWLQJHTXLSPHQW
• When connecting electricity to the mains, a circuit breaker of suitable size must be used.
Warning!
• If the device is installed in a cold environment, make sure that all connections and tubes are properly isolated. Intake and discharge air
ducts should be isolated in all cases.
• Openings of the ducts should be covered during transportation and installation.
• 0DNHVXUHQRWWRGDPDJHWKHKHDWHUZKHQFRQQHFWLQJWKHSLSLQJRIWKHZDWHUKHDWHU)RUWLJKWHQLQJXSXVHDZUHQFKVSDQQHU
Before starting up the device
• make sure, that there are no strange objects inside;
• manually check fans to make sure they are not stuck or blocked;
• if rotary heat exchanger is installed in the device, make sure that it is not stuck or blocked;
• check the earthling;
• PDNHVXUHWKDWDOOFRPSRQHQWVDQGDFFHVVRULHVDUHFRQQHFWHGLQDFFRUGDQFHZLWKWKHZLULQJGLDJUDPRUSURYLGHGLQVWUXFWLRQV