Heating Your Room
You must select the Heat mode if you wish to adjust the :
◆Heating temperature
◆Fan speed when heating
E-14
If the is not displayed on the control panel, press the button on the
remote control one or more times until it appears.
Result: ◆The indoor unit beeps each time you press the button.
◆The air conditioner runs in the Heat mode.
2
You can change modes at any time.
N
No
ot
te
e
You can't control the airflow direction when the fan doesn't operate.
N
No
ot
te
e
To adjust the temperature, press the buttons on the remote control or
but-
tons on the control panel one or more times until the required temperature is
displayed. Possible temperatures are between
61
O
F(
16°C) and
86
O
F(
30°C) inclusive.
Result: ◆Each time you press the buttons:
- The temperature is adjusted by 1
O
F(1°C).
- The indoor unit beeps.
◆The air conditioner starts heating, provided that the room
temperature is lower than the selected temperature.
◆For the first 3~5 minutes, the fan may not operate to prevent
the cool air from running out of the indoor unit.
◆If the room temperature reachs the set temperature, the air
conditioner stops heating, but the fan is still operating.
◆The Defrost indicator( ) appears when frost forms on the outdoor
unit and disappears automatically after removing frost.
3
Select the fan speed by pressing the button on the remote control
or button one or more times until the required setting is displayed :
Result: ◆Each time you press the button, the indoor unit beeps.
Automatic(rotated : ➔➔ )
Low
High
4
To control the direction of the air flow, refer to page 20.
5
1If necessary, press the (On/Off) button.
Result: ◆The power indicator on the control panel comes on.
◆The indoor unit beeps.
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
◆Switched on
◆Stopped
lt will start up normally after three minutes.
IMPORTANT