San Telequip SC12FPIA User manual

San Telequip (P) Ltd.,
504 & 505 Deron Heights, Baner Road
Pune 411045, India
Phone : [phone] Connecting. Converting. Leading !
email : [email protected] .
Page 1 of 3
Manual for Industrial Grade PoE Media Converter, SC12FPIA
Brief introduction
SC12FPIA is in an IP40 rugged strong case, Industrial Level-4 EMC design, which can work
steady in harsh environments. It is an ideal solution to providing network by supporting Auto-
Negotiation and LED indicators.
The device supports redundant power system (12~56VDC), supports DIN-Rail mounted and
Wall-mounted, supports up to 30W power per port for any remote IEEE802.3af/at powered
device (PD) such as PoE IP cameras and PoE wireless LAN access point.
Product Description
DIP Functions
Switch
Status
Function
1 On Pass through mode
Off
Switch mode
2 On Modified cut through mode
Off Store-and-forward mode
3 On NA
Off NA
4 On Enable LFP function(default)
Off Disable LFP function
Name Function
Terminal block Power supply and Ground connector
PWR1 “On”: Power 1 is on and normal
PWR2 “On”: Power 2 is on and normal
POE
“On”: Power over POE port is on and normal
FL/A “On”: Fiber link correct.
“Blink”: Signal packet going through Fx end
100M “On”: 100Mbps
TL/A, L/A “On”: Ethernet link is correct.
“Blink”: Signal packet goes through Tx end
DIP Switch To control the LFP function

San Telequip (P) Ltd.,
504 & 505 Deron Heights, Baner Road
Pune 411045, India
Phone : [phone] Connecting. Converting. Leading !
email : [email protected] .
Page 2 of 3
Pin Out details
1, 2, 3, 6 Data + Power
Pin 1 : RX+, DC+
Pin 2 : RX-, DC+
Pin 3 : TX+, DC-
Pin 6 : TX-, DC-
Mode A, End Span type
Installation
The mounting & unmounting of the DIN
installation is as per the pics shown.
Power
6 PIN Screw terminals, V1+ and V1- is for power
supply 1 (PWR1), V2 + and V2- is for power supply 2
(PWR2) and GND for earthing terminal, as shown in
the Pic.
Power 1 and Power 2 input voltage range is 12VDC
to 56VDC
，
V1+ and V2+ are positive, V1- and V2-
are negative, and the equipment supports reverse polarity protection.

San Telequip (P) Ltd.,
504 & 505 Deron Heights, Baner Road
Pune 411045, India
Phone : [phone] Connecting. Converting. Leading !
email : [email protected] .
Page 3 of 3
Dimensions
Warning
This product is suitable for indoor application.
Place the dust cover on the fiber interface when not in use.
It is dangerous to stare at the fiber transmitter with the naked eye.
Optical fiber transceivers must be used in pair.
Please select a proper Power Supply depending on the product you are buying & the device
you are connecting. We will not cover the damage caused by your using unqualified power
supply.
Trouble shooting
Device is not connecting.
Please check that the corresponding network device is using the same transfer rate as the
media converter (10Mbps, 100Mbps or 1000Mbps).
If power loss is excessive in the fiber, please check and clean the fiber patch cord
connectors.