98127 EN 2.2 - 12 2010 6 / 19 www.santos.fr
SANTOS : Instruction and maintenance manual
DESCRIPTION OF THE APPLIANCE
The beater-mixer can be used to beat, mix and whisk preparations made by
professionals in restaurants, pizza houses, snack bars, catering outlets, sandwich bars,
special theme restaurants, etc.
The appliance consists of an aluminium body and stainless steel plating.
Thanks to the asynchronous motor, it can operate with a hook, paddle, or a whisk
(delivered as standard with the appliance). The working part of the hook and whisk is
made of stainless steel, while the working part of the paddle is made of food quality
aluminium.
3 types of tools
Hook (5): for products that are difficult to process such as bread dough, pizza doughs,
pastry doughs etc.
Paddle (6): for products that need to be mixed and made homogeneous such as
pancake batter, waffle batter, cake mix, choux pastry dough, kneading of meat and fish
preparations, purees, various mixes, etc,.
Whisk (7): for light products that need to be mixed and made homogeneous such as
sponge batters, meringues, butter creams, mayonnaise, whisked egg whites, various
light mixtures, etc.
Bowl made of stainless steel, capacity 9.9 liters, useful capacity 8 liters (e.g. for pancake
batters)
USING THE APPLIANCE
STARTING WORK:
1. After selecting the appropriate tool for the work to be done (hook (5), paddle (6) or
whisk (7)), you can:
a. either fit the tool to the rotating shaft by locking the bayonet system in place,
then install the bowl (2) with or without the products to be processed in it, on
the bowl support (3),
b. or install the bowl (2) with or without the products to be processed in it, on
the bowl support (3) then fit the tool to the rotating shaft by locking the
bayonet system in place.
2. Push the handle (1) backwards to raise the bowl (2).
3. When the handle (1) reaches its end of travel, the bowl (2) is locked in position.
4. Connect the supply cord plug (8) to your mains supply socket.
5. Put the products to be processed in the bowl (2), if this hasn't already been done.
To do this, the safety grid (9) has to be lifted.
6. Select the speed lever (10) position according to the work to be done and the
desired speed. Put the lever (10) in one of the 8 notches in the rack (11) to the right
of the column (12). The first notches towards the front are for high speeds
