Sanus Systems VISIONMOUNT VMXA1 User manual

Assembly Instructions for Model: VMXA1
Thank you for choosing a Sanus Systems VisionMount™ Model: VMXA1. The VMXA1 is 8″ [203 mm] longer and replaces the Center
Plate provided with the VMPL3. The VMXA1 is designed to hold up to 280 lbs [127 kg].
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 08.02.06 (100042)
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
Step 1: Congure Wall Plate Assembly
NOTE: VMXA1 replaces the standard Center Plate in the Wall Plate Assembly (A) provided with the VMPL3. These instructions
replace Step 7: Congure Wall Plate Assembly, of the Assembly Instructions for Model: VMPL3.
Using the VMXA1, the Wall Plate Assembly (A) can be adjusted in width from 35″ to 50″ [889 mm to 1270 mm]. Determine how wide you
want the Wall Plate Assembly based on the following criteria:
• Width of television (Wall Plate Assembly should be congured so the total width is less than the overall width of your television)
• Width of Hole Pattern on television (Wall Plate Assembly should be wider than the horizontal distance between threaded inserts on the
back of your TV by at least 2″ [50.8 mm])
• Stud Spacing (Sanus recommends attaching Wall Plate Assembly to three studs for televisions over 125 lbs. [56.7 Kg])
To adjust the width of the Wall Plate Assembly (A) using the VMXA1:
Remove each Flange Nut and Nylon Washer from the Wall Plate Assembly (A) as shown in Diagram 1A.
Diagram 1A
Flange
Nut
Wall Plate
Assembly (A)
Nylon
Washer
Remove the Center Plate of the Wall Plate Assembly (A) as shown in Diagram 1B.
Diagram 1B
Center
Plate

Using the previously removed Flange Nuts and Nylon Washers, secure the Right and Left Extension to the VMXA1 as shown in Diagram
1D, and securely tighten the Flange Nuts.
Diagram 1D
Flange
Nut Nylon
Washer
Left
Extension
VMXA1
Right
Extension
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 08.2.06 (100042)
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
Separate the Left and Right Extension of the Wall Plate Assembly (A) and set them to so that their outer edges are equal to the desired
width.
NOTE: All four of the Threaded Studs must pass through the VMXA1 for the installation to be safe.
Insert the VMXA1 so the teeth on its bottom t into the slots in the Left and Right Extension, making sure that the Threaded Studs t
through the center row on holes in the VMXA1 as shown in Diagram 1C.
Diagram 1C
Left
Extension
VMXA1
Right
Extension
Threaded
Studs