[COMPACT DISC PREPARATIO-NS ~
I.—
This unit is designed to play compact discs bearing the
identification logo below. Discs that do not carry this logo
may not conform to the CD standard and may not play
properly.
This unit can be used to play 12 cm discs only.
mm
COMPACT
DIGITAL AUDIO
Do not attempt to load a 8 cm disc with or without a
snap-on adaptor. Doing so may cause damage to the
disc and CD changer.
Fingerprints and dust should be carefully wiped off
the signal surface of the disc (glossy side) with asoft
cloth.
Wipe in astraight motion from the centre to the
outside of the disc.
Never use chemicals such as record cleaning sprays,
antistatic sprays or fluids, benzene orthinnerto clean
compact discs.
These chemicals will permanently damage the plastic
surface of the disc.
Always place the compact disc in the disc tray with the
label facing upward. Compact discs can be played on
only one side.
To remove adisc from itsstoragecase, press down on
the centre of the case and lift the disc out, holding it
carefully by the edges.
Discs should be returned to their cases after use to
protect them from dust and scratches.
To prevent warping the disc, do not expose it to direct
sunlight, high humidity or high temperatures for ex-
tended periods of time.
Do not apply paper or write anything on either side of
the compact disc. Sharp writing instruments, or the
inks used in some felt-tip pens, may damage the
surface of ‘he disc.
Important Notes:
1)
2)
When positioning the unit for use, be sure to place it
on aflat surface so that it does not tilt.
When carrying the unit from one location to
another ...
When moving the unit ashort distance, such as
from room to room, turn the power off and wait at
least 10secondsforthe CDchanger mechanism to
reset.
Lift the unit by the handle and be sure to keep the
3) unit in ahorizontal position.
When transporting the unit ...
-Remove all the discs from the unit.
Carrying the unit around with discs inside can
cause damage tothe discs and maycausethe unit
to malfunction.
Press the POWER button to turn off the power and
wait at least 10secondsfor the CDchanger mecha-
nism to reset before carrying the unit.
IMPORTANT INFORMATION
Sanyo compact disc changers have built-in error compen-
sation circuits to correct for minor manufacturing defects
in adisc. There are limits, however, to the amount of
correction possible.
In some cases, the CD changer may skip some tracks on a
disc during play. This problem may be caused by defects
(such as scratches) in the disc being played, which are too
large for the error compensation circuits to handle. If you
encounter this problem, check the operation of the CD
changer as follows, before having the unit serviced.
Play anew disc. If the CD changer operates normally,
the skipping problem is most likely due to adefective
disc.
-8-
