Sanyo POA-SR-140 User manual

MODEL POA-SR-140
Smoke Resistant Box
Owner's Manual

Before operating this Projector, read this manual thoroughly and operate the projector properly.
Provide appropriate space on the top, sides and rear of the Projector and Smoke Resistant Box for allowing
air circulation and cooling the Projector. Minimum clearance must be maintained. If the Projector is to be
built into a compartment or similarly enclosed, the minimum distances must be maintained. Do not cover the
ventilation slot on the Projector and Smoke Resistant Box. Heat buildup can reduce the service life of your
projector and Smoke Resistant Box, and can also be dangerous.
READ AND KEEP THIS OWNER'S MANUAL FOR LATER USE.
2
TO THE OWNER
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO
USER-SERVICEABLE PARTS INSIDE EXCEPT FILTER REPLACEMENT. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
WARNING :
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
THIS SYMBOL INDICATES THAT DANGER-
OUS VOLTAGE CONSTITUTING A RISK OF
ELECTRIC SHOCK IS PRESENT WITHIN
THIS UNIT.
THIS SYMBOL INDICATES THAT THERE
ARE IMPORTANT OPERATING AND MAIN-
TENANCE INSTRUCTIONS IN THE OWN-
ER'S MANUAL WITH THIS UNIT.
Federal Communication Commission Notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If such
changes or modifications should be made, you could be required to stop operation of the equipment.
CAUTION
This is a Class A equipment. This equipment can cause interference in residential areas; in this case, the operator
can be asked to take adequate countermeasures.
The CE Mark is a Directive conformity mark of the European Community (EC).

•The Smoke Resistant Box protects the projector
from dust and cigarette smoke by adopting a highly
efficient filter.
•Provide two powerful silent rotary fans, and cool
down the Projector efficiently.
•It has been designed for easy mounting.
3
FEATURES
FEATURES
FEATURES ················································································································ 3
PART NAMES············································································································ 4
INSTALLATION ········································································································· 5
OPERATION ·············································································································· 7
FILTER REPLACEMENT···································································································· 8
FILTER TIME CHECK AND RESET··················································································· 10
APPENDIX·················································································································11
MAINTENANCE ················································································································· 11
TROUBLESHOOTING········································································································ 11
DIMENSIONS
SPECIFICATIONS
TABLE OF CONTENTS

4
PART NAMES
PART NAMES
MOUNTING SCREWS
(provided on each corner)
(Screws are provided in the holes)
INDICATORS
CONNECTOR
FILTER
FILTER COVER
(AIR INTAKE VENTS)
REAR
FRONT

Please ensure that there is sufficient clearance around the unit at the time of installation, as shown in the
figure on the right.
Take out the Smoke Resistant Box from the
packaging and place it on a flat surface with the
projector.
Take off the connector cover from the Projector.
5
INSTALLATION
INSTALLATION
PRECAUTION BEFORE INSTALLATION
PRECAUTION BEFORE INSTALLATION
PRECAUTION BEFORE INSTALLATION
WARNING: DO NOT COVER INTAKE
VENTS.
If the Air Intake is covered, there will be in-
sufficient cooling which may result in failure
or fire.
CAUTION:UNPLUG THE PROJECTOR FROM THE AC OUTLET WHEN INSTALLING THE
SMOKE RESISTANT BOX.
ATTACHING THE SMOKE RESISTANT BOX WHILE THE PROJECTOR IS CONNECTED TO
ELECTRICITY MAY DAMAGE THE BOX OR CAUSE IT TO MALFUNCTION.
AIR INTAKE VENTS
At least 20'' (50cm)
30''
(75cm)
At least
At least
40''
(100cm)
FRONT
PROCEDURE OF INSTALLATION
PROCEDURE OF INSTALLATION
PROCEDURE OF INSTALLATION
1
2
CONNECTOR COVER
RETAIN THE CONNECTOR COVER.
WHEN THE SMOKE RESISTANT BOX IS NOT
BEING USED, REATTACH THE CONNECTOR
COVER TO THE PROJECTOR TO PROTECT
THE CONNECTOR.

Align the connector of the Projector with the
connector pins of the Smoke Resistant Box.
Hold the Smoke Resistant Box parallel to the
Projector and push it slowly towards the Projector.
Hold the Smoke Resistant Box with one hand and
use a Phillips-head screwdriver to tighten the four
fixed screws to fix the box in place.
Check that the Smoke Resistant Box is fixed in place with the four screws and no wide gap exists
between the projector body and the box.
6
INSTALLATION
3
4
5
6
CAUTION: TAKE CARE NOT TO TOUCH
THE CONNECTOR OR APPLY SHOCK
THAT MAY DAMAGE THE CONNECTOR.
PINS
PHILLIPS-HEAD
SCREWDRIVER
THERE SHOULD BE NO WIDE GAP THERE SHOULD BE NO WIDE GAP

When the Projector is turned on, the POWER indicator lights in green.
*When the POWER indicator does not light and the WARNING FILTER indicator flashes, the filter is not
attached to the Smoke Resistant Box. In this case, the READY indicator on the Projector does not light
and the Projector can not be turned on.
INDICATORS OPERATION
WARNING FILTER. . . . Normally this does not light. Should the filter become clogged with dust particles
indicator flashes orenge. When the filter needs to be replaced, indicator lights in
orange. The filter should then be replaced immediately. When the filter is not
attached, the indicator will flash.
WARNING . . . . . . . . . . Normally this does not light. When the box's fan is operating abnormally, indicator
flashes red. When this occurs, turn off power immediately and request a
maintenance check. Do not leave the Smoke Resistant Box operational while the
indicator is flashing as it may become a fire and/or accident hazard.
When the Smoke Resistant Box is used for the first time, the initial set-up should be performed in the
following procedures. The Smoke Resistant Box cannot be operated or handled properly without this initial
set-up.
First, properly attach the Smoke Resistant Box to
the Projector.
Turn on the Projector and display some images.
Check that each indicator on the Smoke Resistant
Box lights normally.
Go to next page
7
OPERATION
1
2
OPERATION
INDICATORS
ORANGE
REDGREEN
OFFOFFON
INITIAL SET-UP BEFORE USE
INITIAL SET-UP BEFORE USE
INITIAL SET-UP BEFORE USE

Select [SPECIAL] in the Projector's menu. Then select [Filter].
Select [Option box] and then select [Reset] and then [ Yes].
A message [Please wait---] will appear.
When this message disappears initial set-up is complete. Close the menu.
When replacing the filter, replace with a specified filter. A replacement filter can be ordered through your
dealer. When ordering the filter, give the following information to the dealer.
• Replacement Filter type No. : POA-FIL-140
• Smoke Resistant Box type No. : POA-SR-140
Press the PUSH button on the filter cover.
8
OPERATION
FILTER REPLACEMENT
3
4
PUSH BUTTON
CAUTION:WHEN REPLACING THE FILTER, TURN OFF THE PROJECTOR.
1

Open the filter cover and take out the used filter.
Install the new filter.
Check that the filter is not tilted or warped and then
close the filter cover. This will lock it into place.
Reset the filter time.
Refer to "FILTER TIME CHECK AND RESET"
9
OPERATION
2
3
4
5
FILTER COVER
USED FILTER
CAUTION: USE ONLY REPLACEMENT
FILTERS RECOMMENDED BY THE
MANUFACTURER. THE USE OF OTHER
FILTERS MAY CAUSE THE BOX TO
MALFUNCTION OR ACCIDENT MAY
RESULT.
CAUTION:TAKE CARE NOT TO DAMA-
GE THE FILTER DETECTION SWITCH
LOCATED INSIDE THE BOX WHEN IN-
SERTING THE FILTER.
NEW FILTER
FILTER DETECTION
SWITCH

The filter operation time can be checked in the
projector menu.
Open [INFORMATION] in the menu and check
[Option filter time] for the hour counter.
"Option filter time" menu will not exist when Smoke
Resistant Box is not attached on the projector.
Reset the filter time according to the following procedures:(Only reset the filter time when changing the filter.
The Smoke Resistant Box cannot be operated properly if it is reset other than filter change.)
Check that the Smoke Resistant Box is properly
attached to the projector.
Turn on the projector and display the screen.
Check all indicators on the Smoke Resistant Box
light normally.
Select [SPECIAL] in the projector's menu. Then
select [Filter].
Select [Option box] and then select [Reset] and then
[Yes].
A message [Please wait--] will appear. When it disappears Filter Time reset is completed. Close the
menu.
10
OPERATION
FILTER TIME CHECK AND RESET
1
2
3
4
5
FILTER TIME CHECK
FILTER TIME CHECK
FILTER TIME CHECK
RESETTING THE FILTER TIME
RESETTING THE FILTER TIME
RESETTING THE FILTER TIME
OFFOFFON
•
•
※

IF THE SMOKE RESISTANT BOX IS NOT USED LONG PERIOD OF THE TIME.
Remove the Smoke Resistant Box from the Projector and store in safe place.
CARE AND CLEANING OF THE CABINET.
Remove stains on the cabinet with a soft cloth. If the stain is particularly stubborn, use a cloth soaked in
a heavily diluted mild detergent, and finish with a dry cloth.
CARE FOR THE CABINET.
Do not apply volatile solvents such as insecticide to the cabinet or bring the casing into contact with
rubber, adhesive tape or vinyl products for a long time. This may result in degradation and paint
scratches.
DO NOT USE BENZENE OR THINNER.
If benzene or thinner is used, cabinet may be damaged. When using a chemical cloth, please follow the
instructions carefully.
CLEANING AIR INTAKE VENTS.
When using under dusty or smoky conditions, the performance may be impaired.
Remove dust frequently using a vacuum cleaner, etc.
11
APPENDIX
MAINTENANCE
•
•
•
•
•
TROUBLESHOOTING
PROBLEM
PROBLEM
TRY THESE SOLUTIONS
TRY THESE SOLUTIONS
PROBLEM TRY THESE SOLUTIONS
NO POWER. Check that the Projector is connected to a power source.
Check that the POWER indicator is illuminated green.
When the WARNING indicator flashes red, the built-in rotary fan has malfunctioned and
halted operation. Please consult with your dealer agent.
Check if the orange WARNING FILTER indicator is flashing. The filter may have come loose.
•
•
•
•
WARNING FILTER
INDICATOR ILLUMI-
NATES ORANGE.
When the WARNING FILTER indicator flashes or lights in orange, the filter should be
replaced with a new filter immediately.
•

SMOKE RESISTANT BOX
ACCESSORIE
APPENDIX
DIMENSIONS
SPECIFICATIONS
(461mm)
18.1''
(216mm)
8.5''
(165mm)
6.5''
TOP
FRONT RIGHT SIDE
ITEM
ITEM
CONTENTS
CONTENTS
ITEM CONTENTS
TYPE Projector smoke proof and dustproof box
DIMENSIONS 6.5''x8.5"x18.1" (165mm x 216mm x 461mm)
NET WEIGHT Approximately 7.5lbs (3.4Kg)
AIR CAPACITY Approximately 2.0m /min
3
INDICATORS POWER, WARNING FILTER, WARNING
OPERATING CONDITIONS 41 to 95 (5 to 35 ) (indoors)
Owner's Manual Smoke Resistant Box1
NAME
NAME
QUANTITY
QUANTITY
CONTENTS
CONTENTS
NAME QUANTITY CONTENTS
SANYO Electric Co., Ltd
Printed in Japan