sauermann Si-RV3 User manual

Si-RV3
DOWNLOAD THE APPLICATION
PAIR THE PROBES
Press “Connect the probe” on
the left-hand corner of the screen.
Press “Search for probes”.
Turn on the low
pressure probe.
Select the probe to pair and
press “Pair”.
After a few seconds, measured
values are displayed.
SAFETY INSTRUCTIONS
SIMPLIFIED USER MANUAL
Please refer to the complete user manual of the Si-Manifold application to get more information
about safety instructions.
➢Go to Google store or App store.
➢Search for “Si-Manifold” application.
➢Install the application.
It is also possible to download the application by flashing the following R code:
●This device has been developed for the pressure and temperature measurements and settings on stationary or
mobile refrigeration equipment. It must not be used in any other purpose.
●This device has been developed, produced and sold exclusively to trained and qualified experts in the field of
HVACR. Appropriate training is necessary in order to guarantee a riskless use of this instrument. Sauermann is not
responsible for any possible accident during its use.
●Please always use the device in accordance with its intended use and within parameters described in the technical
features in order not to compromise the protection ensured by the devices.
●Maximum operating pressure: 65 bar (942 psi)
●The device must not be used with ammoniac refrigerant gas (NH3 / R717)
●Do not use the device if it is damaged or if it operates abnormally. Inspect the device before every use.
●Always wear protective glasses and gloves when using the Manifold in order to protect
your eyes and skin when operating refrigerant gases. The vapours of refrigerant gases
are extremely cold. Do not expose your skin to these vapours.

LAUNCH A MEASUREMENT / DISPLAY DIFFERENT VIEWS / ACCES TO PARAMETERS
Press
Launch the measurement Display different vie s of the measured values
Press to display the values curves
or press to display the values table.
Access to the application parameters
Press Parameters list
CONNECT THE Si-RV3
➢Press on the bottom of the screen to go to “Vacuum” mode..
➢Connect the vacuum probe on the system to control.
For vacuum measurements:
NTang simplified_Si-RV3 – 07/09/17 – Non-contractual document – We reserve the right to modify the characteristics of our products without prior notice.
Read the
complete user
manual of the Si-
Manifold app to
get information
about all the
available
functions.