sauermann 25555-V User manual

Si-RM3
Please refer to the complete user manual of the Si-Manifold application to get more information
about safety instructions.
SIMPLIFIED USER MANUAL
DOWNLOAD THE APPLICATION
➢Go to Google store or App store.
➢Search for “Si-Manifold” application.
➢Install the application.
PAIR THE PROBES
Press “Connect the probe” on
the left-hand corner of the screen. Press “Search for probes”.
Turn on the low
pressure probe.
Select the probe to pair and
press “Pair”.
After a few seconds, measured
values are displayed.
and then perform
the same procedure
to pair the high
pressure probe
Example with the low pressure probe Before any measurement, perform an auto-zero of the probe in fresh air.
Perform an auto-
ero of the probe in
fresh air by pressing
It is also possible to download the application by flashing the following QR code:
SAFETY INSTRUCTIONS
●This device has been developed for the pressure and temperature measurements and settings on stationary or
mobile refrigeration equipments. It must not be used in any other purpose.
●This device has been developed, produced and sold exclusively to trained and qualified experts in the field of
HVACR. Appropriate training is necessary in order to guarantee a riskless use of this instrument. Sauermann is not
responsible for any possible accident during its use.
●Please always use the device in accordance with its intended use and within parameters described in the technical
features in order not to compromise the protection ensured by the devices.
●Maximum operating pressure: 65 bar (942 psi)
●The device must not be used with ammoniac refrigerant gas (NH3 / R717)
●Do not use the device if it is damaged or if it operates abnormally. Inspect the device before every use.
●Always wear protective glasses and gloves when using the Manifold in order to protect
your eyes and skin when operating refrigerant gases. The vapours of refrigerant gases
are extremely cold. Do not expose your skin to these vapours.
www. .com [e-mail]1.800.561.8187

LAUNCH A MEASUREMENT / DISPLAY THE REFRIGERANTS LIST / ACCESS TO PARAMETERS
Press
Launch the measurement Display the refrigerants list
Press
Refrigerant gases list
Access to the application parameters
Press Parameters list
Read the
complete user
manual of the Si-
Manifold app to
get information
about all the
available
functions.
CONNECT THE Si-RM3
➢Connect the low pressure probe on the system to control.
➢Connect the high pressure probe on the system to control.
For pressure measurements
➢Connect the temperature clamp on the pressure probe.
➢Position the temperature clamp on the pipe.
For pipe temperature measurements
Before any measurement, perform an auto-zero of the probe at fresh air.
➢Press on the bottom of the screen to go to “Manifold” mode.
NTang_simplified_Si-RM3 – 07/09/17 – Non-contractual document – We reserve the right to modify the characteristics of our products without prior notice.
www. .com [e-mail]1.800.561.8187