Schlage 04-032 Instruction sheet

HOW TO INSTALL THE 04-032 RETROFIT LEVER
04-032 RETROFIT LEVER for “D”
series locksets*
with Orbit, Plymouth or Tulip
design knobs.
*Not for use with interchangeable
core knob designs.
1. REMOVE KNOB
To remove existing knob
from lock unit insert
pointed end of spanner
wrench, or small nail,
into hole in outside knob
sleeve. Exert pressure
and turn key slowly until
knob catch depresses.
Pull off knob.
Remove knob sleeve.
(Sleeve is not used with
retrofit lever.)
2. LEVER/KNOB
INSTALLATION
Place lever in position
onto back of knob (TULIP
design requires spacer
(provided) inserted into
cup of lever.) Position lever
on knob so that end of
lever will point toward
hinge side of door when
knob is reinstalled.
DEPRESS KNOB CATCH
REMOVE KNOB SLEEVE
KNOB SLEEVE
SPACER RETROFIT LEVER
P509-464

3. ASSEMBLE
LEVER/KNOB
Insert lever retaining
plate cog into
knob-catch slot on the
knob shank. Snap
retainer plate into
place. Complete
installation of retainer
plate with provided
screws. Screw down
completely so that
screws are flush with
retainer plate.
4. REPLACE
KNOB/LEVER
Slide the assembled
retrofit lever & knob on
spindle. Depress knob
catch, exert pressure,
turn key slowly and
push lever assembly
into position. Pull knob
to test fastening of
catch. Test lock for
operation.
For additional information see Service Manual 50-100.
RETAINING PLATE
COG
SCREWS
push
SPINDLE
KNOB CATCH SLOT
KNOB CATCH
LINE UP LUG IN KNOB SHANK WITH SLOT IN SPINDLE.
©2010 Schlage Lock Company
800-847-1864
Printed in Country
P509-464 Rev. 07/10-b