Schlage Encode User manual

Quick Start Guide

Backup
Key
Touchscreen
Assembly
Battery
Cover
Inside
Assembly
Backplate
Reinforcement
Plate
Bolt
Strike
Reinforcement
Screws
Inside Assembly
Screws
Backplate
Screws
Bolt/Strike
Screws
Parts

Visit schlage.com/encode-workswith
to setup and control your
with your smartphone.
Start here!
schlage.com/encode-workswith

Communication Icon
•Flashes when lock is connecting
to WiFi to check for updates.
Low Battery Icon
•Flashes after code is entered
when battery is low.
•Solid when battery is critical.
The lock will not work without
new batteries.
Programming and Input
LED
•Flashes white on every digit
that is entered.
•Amber when using manual
programming mode.
Home Button and
Checkmark Icon
•Turns on keypad backlight.
•Starts WiFi connection
process.
•Checkmark ashes when
code entry is correct.
•Checkmark ashes when
manual programming are
successful.
Lock Button and “X” Icon
•Locks the lock.
•Turns on keypad backlight if
the lock is locked.
•“X” ashes for a wrong user
code.
Touchscreen

1
step
Remove existing lock.
Remove the entire deadbolt, including the bolt.
You may also want to remove the strike. A standard
Schlage deadbolt is shown. Check with your specic
deadbolt manufacturer if you need help.
Tools
Don’t use a power drill!
Phillips screwdriver
1 2 3
4 5

Need Help?
Visit schlage.com/faqs-encode.
2
step
Actual Size
Make sure the
word “TOP” is
facing up.
Install the bolt.
You may have to adjust your bolt length. Make sure the slot in
the bolt is centered in the hole.
Slot is
centered
in the hole.
No change
needed.
Twist the
faceplate to
extend. Keep
twisting
until 2 ¾”.

Install the strike into the door frame.
3
step
Actual Size
Actual Size
Install
this strike
reinforcer for
enhanced
security.
Need Help?
Trouble installing the strike reinforcer?
Visit schlage.com/faqs-encode
and follow interactive instructions.
If you have a window next to your door, you may not be able
to use the longer wood screws to install the reinforcer.

4
step
Install the touchscreen.
Route the cable through the door BELOW the bolt. Align the
tailpiece as shown and push the touchscreen onto the door.
Is it hard to install the touchscreen?
Is the tailpiece not installing correctly?
If your through hole seems too small, you
may need to remove the spacer. Visit
schlage.com/faqs-encode.
The bump on
the tailpiece
aligns with the
slot in the bolt.

5
step
Install the backplate.
Route the cable under the bolt and through the hole on
the bottom of the backplate. Secure the backplate with
screws. Make sure the outside touchscreen is straight before
tightening screws all the way.
Don’t use a power drill!
You may damage your
lock!
Phillips screwdriver
1 2 3
4 5

6
step
Connect the cable.
Tuck the cable and connector in the space above the spindle.