Pressing the Accelerator lever, up to the maximum travel, for 10" (seconds)
the scooter will maintain the same speed even when releasing the lever.
Function Fault:
4. Brake - e-brake + disc brake, when brake, the rear light will be flashing.
5. How to change speed? After power on, default is the lower speed. Switch the speed by
quick pressing two times the Power On/off button within 1 second.
6. Battery indicator
• 33v-36v One battery bar light
• 36v-37v Two battery bar light
• 37v-38.5v Three battery bar light
• 38.5v above All battery bar light
Low voltage warning: the 1st battery bar flashing once voltage is lower than 33V
7. Low voltage warning mode: Under this mode, the speed limitless is 6Km/h.
8. Auto Cruise - Speed Cruise activated automatically after same speed for 10 seconds, then
you can release the speed controller; press brake controller or press again the speed
controller, scooter returns back to manual mode.
9. Speed Setting:
• White S <=6km/h
• Orange S<= 15km/h
• Red S<= 25km/h
10. Auto Power off - After 10mins without any operation, it will be powered off automatically
Fault Code
E.1
E.2
E.3
E.4
E.5
E.6
Instruction
E-accelerator fault
Battery voltage over 42V
Battery voltage below 32V
Output Current exceeds 14A
Motor Hall wire fault
Motor stuck
E.7
E.8
Motor phase line fault
Front or Rear Light failure
ATTENTION
Check the battery charge level with the vehicle stationary.
ATTENTION
06
