Seafloor HydroCat-180 TARANIS X7 Installation manual

TM
TARANIS X7 Controller
AutoNav
Up:Manual Mode
Down:Auto Mode
Winch Control Knob
Arming Safety
Switch
Power:ON/OFF
AutoNav
Up:Arm
Down: Disarm
Forward
Left Right
Reverse
Start Up Arm HydroCat-180
1Center all switches and joysticks.
2Hold Power button until all four loading
process dots appear on the screen.
3If Switch Warning appears, make sure all
switches are turned off or centered
(Winch Knob center), auto switch is set to
Manual and arming is set to Disarm.
1To arm the HydroCat’s AutoNav move
arming switch to arming position then
hold arming toggle switch up for 3
seconds. You will hear the HydroCat
AutoNav chime when arming is complete.
2To Disarm, switch the Arm switch to
Disarm and hold arming safety switch
for 3 seconds. The AutoNav will chime
when disarmed.
Seafloor Systems, Inc. [email protected] 1 (530) 677 - 1019
Pole Actuator
Up: Recover
Down: Deploy
HydroCat-180™

Seafloor Systems, Inc. [email protected] 1 (530) 677 - 1019
Optional Long Range Module
1Install R9M with antenna on the back side of the remote.
2Plug in external 2s battery to the R9M.
Rev 10/16/2020