Sealey Premier SA37/96B User manual

PREMIER ANODISED DIGITAL TYRE INFLATOR
WITH TWIN PUSH-ON CONNECTOR
MODEL NO: SA37/96B
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9Disconnect the inflator from the air supply before changing accessories, servicing or performing any maintenance.
9Maintain the inflator in good condition (use an authorised service agent), and keep the gauge clean for best and safest performance.
9Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9Locate inflator in a suitable work area, keep area clean and tidy and free from unrelated materials and ensure there is adequate lighting.
9Keep children and unauthorised persons away from the work area.
8DO NOT direct inflator outlet at yourself or at other persons or animals.
8DO NOT carry by the hose, or yank the hose from the air supply.
8DO NOT use the inflator for a task which it is not designed to perform.
8DO NOT operate the inflator when you are tired, under the influence of alcohol, drugs or intoxicating medication.
8DO NOT operate the inflator if any parts are missing or the inflator is damaged, as this may cause failure and/or personal injury.
8DO NOT exceed maximum permissible tyre pressure
2. INTRODUCTION
Anodised black aluminium body with impact absorbing rubber bumper. Features auto power on/power off backlit LCD digital display
 foreaseofuse.Calibratedinpsi,barandkPa.0.5mexiblehosettedwith240mmtwinpush-onairconnector.Featuresabattery
 levelindicator,poweredby2xAAAbatteries(supplied).Suppliedwithaserialnumberedcalibrationcerticate.3yearwarranty.
3. SPECIFICATION
Model no: ..............................................................SA37/96B
Range: ................. 0.3-17.2bar(4-250psi)(30-1720kPa)
Accuracy: ............ 5-60±1psi,61-145±2psi,146-250±3.6psi
Pressure units: ................................................... bar, psi, kPa
Inlet size:..................................................................1/4”BSP
Battery: .....................................................2xAAA(supplied)
Battery run time:..................................................... 400hours
4. OPERATION
4.1. BATTERY CHANGE (g.2,g.3,g.4)
4.1.1. Theinatorrequires2AAAbatteries.
4.1.2. Whenthebatterystateindicatorsymbol(g.1)showsempty,the
batteries need replacing.
4.1.3. Unscrew the end cover, remove old batteries and replace with new ones.Replaceendcover-DO NOT overtighten it.
4.2. ON / OFF / UNITS
4.2.1. TheunitswitchesonwheneithertyrepressureissensedortheOnbutton(g.1)isdepressed.
4.2.2. Tochangeunitsofmeasurementholddownthebutton(g.1)for2secondstocyclethrougheachoption(bar,psi,kPa).
4.2.3. Theunitswitchesitselfoffapproximately25secondsafteritslastuse.
SA37/96BIssue119/08/19
Original Language Version
©JackSealeyLimited
Refer to
instructions
g.1
g.2 g.3 g.4

4.3. INFLATE / DEFLATE
4.3.1. Toinateatyrelocatethevalveconnectorsquarelyandrmlyontothetyre’svalve.Depressthelever(g.5)for10-20seconds,
release the lever and check tyre pressure reading. Continue until the required pressure is achieved.
4.3.2. Todeateatyrelocatethevalveconnectorsquarelyandrmlyontothetyre’svalve.Slowlydepressthelever(g.5)toitshalfway
 positionwhenescapingaircanbeheard.Holdsteadyfor10to20secondsthenreleasetheleverandchecktyrepressure 
reading. Continue until the required pressure is achieved.
5. MAINTENANCE
5.1. Regularly check condition of all hoses. Replace if necessary.
5.2.  Regularlycheckxings.Re-tightenorreplaceifnecessary.
5.3. To clean the unit, wipe with a damp cloth.
Original Language Version
©JackSealeyLimited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
BATTERY REMOVAL
UndertheWasteBatteriesandAccumulatorsRegulations2009,JackSealeyLtdarerequiredtoinformpotentialpurchasersofproducts
containingbatteries(asdefinedwithintheseregulations),thattheyareregisteredwithValpak’sregisteredcompliancescheme.Jack
SealeyLtdBatteriesProducerRegistrationNumber(BPRN)isBPRN00705.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty:Guaranteeis36monthsfrompurchasedate,proofofwhichisrequiredforanyclaim.
Parts support is available for this product. Please log on to
www.sealey.co.uk,email[e-mail]ortelephone01284757500
SA37/96BIssue119/08/19
g.5