SEASIDE CASUAL FURNITURE 60 User manual

1
Tools Required:
Phillip’s Head Screwdriver
7/16 Socket or Wrench
4MM Allen Wrench (Included)
(60,61) Adirondack Classic & Shellback Bar Chair rev. A
WOODENVIRO
SEASIDE CASUAL FURNITURE
Hardware:
(10) 3-1/2” Connector Bolts
(12) 2-3/4” Connector Bolts
(6) 1-3/4” Phillip’s Head Screws
(22) Flat Washers
(22) Lock Washers
(22) Nuts
(4) 3” Hex 1/4” Lags
(1) Seat Assembly
(1) Back Assembly
Parts List:
Assembly Instructions
Step One: Set Up
READ ENTIRE INSTRUCTIONS BEFORE BEGINNING! Carefully remove contents
from box. Make sure that all parts and hardware are included.
Place Seat Assembly on a flat clean surface. Align Front & Rear
Legs (5) pre-drilled holes with Seat Assembly pre-drilled holes. Use
(5) 3-1/2” connector bolts. Finger tighten bolts with flat & lock
washers and nuts. Make sure long ends of Front & Rear Legs are be-
low Seat Assembly (Right Picture). Do not tighten at this time. Flip
chair over and repeat process for the other side.
Step Two: Leg Assembly
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
Step Three: Back Assembly
Place chair to standing position. Place
Back Assembly on top of mounting sur-
face of Rear Legs. Push Back Assembly
forward until it is aligned with Seat As-
sembly (Left Picture). Hold Back Assem-
bly in place and install using (2) 1-3/4”
Phillip's Head Screw into pre-drilled holes
on both sides of Assembly (Right Picture)
(2) Front Legs (Straight Ends) (2) Back Legs (Angled Ends)
(2) Arm Assemblies
(1) Rear Seat Apron (3-1/2” Wide)
Instruction Revision: A
(2) Side Leg Stretchers
(1) Rear Leg Stretcher (2-1/2” Wide)
(1) Foot Rest

2
Tighten all connections. Do not over tighten!!! Over tightening of hardware can cause
damage to the item.
Step Four: Arm Assembly
Step Nine: Tightening of Hardware
Step Five: Arm & Back Attachment
Install (1) 2-3/4” connector bolt through pre-drilled hole through arm
and through upper back yoke (Left Picture). Finger tighten flat &
lock washers and nuts. Do not tighten at this time. Repeat process for
opposite side.
Place Arm Assembly on top of Front Leg
and Upper Back Yoke (Left Picture). Align
hole in Arm Assembly with the hole lo-
cated at the top of the Front Leg. Install us-
ing (1) 2-3/4” connector bolt through hole
in underarm support and though Front Leg
with flat & lock washers and nuts (Right
Picture). Do not tighten at this time. Repeat
process on other side.
Step Six: Rear Seat Apron
Install the Rear Seat Apron using (2) 1-3/4” Phillip's Head Screws
(Right Picture).
Install (2) Side Leg Stretchers using (6) 2-
3/4” connector bolts. Finger tighten with
flat & lock washers and nuts. Do not
tighten at this time (Left Picture).
Install Rear Leg Stretcher using (2) 1-3/4”
Phillip’s Head Screws.
Step Eight: Side & Rear Leg Stretchers
Step Seven: Foot Rest Assembly
Install Foot Rest using (4) 3” Hex 1/4” Lags (Left Picture)