SEASIDE CASUAL FURNITURE Adirondack Classic User manual

1
Hardware List:
(12) 3-1/2” Connector Bolts
(2) 2-3/4” Connector Bolts
(14) Flat Washers
(14) Lock Washers
(14) Nuts
(4) 1-3/4” Phillip’s Head Screws
Tools Required:
Philip's Head Screwdriver
7/16 Socket or Wrench
(1) 4MM Allen Wrench (Included)
SEASIDE CASUAL FURNITURE
(11,19) Adirondack Classic & Shellback Rockers rev. A
WOODENVIRO
(1) Seat As-
sembly
(1) Back As-
sembly
(2) Front
Rocker Legs
(2) Arms
Parts List:
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
Assembly Instructions
Step One: Set Up
READ ENTIRE INSTRUCTIONS BEFORE BEGINNING! Carefully remove contents
from box. Make sure that all parts and hardware are included.
Place Seat Assembly on it’s side on a flat clean surface. Locate
the Front Leg with Rocker that you will be installing (Right Pic-
ture). Insert a 3-1/2” connector bolt up through the outermost
pre-drilled hole in front leg and align this with the pre-drilled
hole in the seat assembly and install the flat washer, lock
washer, & nut. Finger tighten nut, then install second and third 3
-1/2” connector bolts next to the one you have just installed. In-
stall (2) 3-1/2” connector bolts to attach back of Rocker to Rear
Leg (Right Picture). Flip the chair over and repeat process for
the other side. Do not tighten at this time.
Arms should be installed with curve side on the inside of the
chair (Left Picture). Place Arm on top of Front Leg. Align
pre-drilled hole in arm with the pre-drilled hole located at
the top of the Front Leg. Install a 3-1/2” connector bolt
through pre-drilled hole in Front Leg, then through pre-
drilled hole under arm. Install flat washer, lock washer, and
nut. Do not tighten at this time. Repeat process on other
side.
Step Three: Arm Assembly
Step Two: Leg Assembly
Instruction Revision: B

2
Place Seat Assembly on top of mounting surface of Rear Legs
(Left Picture). Push Back Assembly forward until it’s aligned
with Seat Assembly. Hold Back Assembly in place and install
(4) 1-3/4” Phillip’s Head Screws into pre-drilled holes on each
side.
Install (1) 2-3/4” connector bolt through pre-drilled hole
through arm and through upper back yoke (Right Picture).
Finger tighten flat & lock washers and nuts. Do not tighten at
this time. Repeat process for opposite side.
Tighten all connections. Do not over tighten!!! Over tightening of hardware can cause
damage to the item.
Step Six: Tightening of Hardware
Step Four: Arm & Back Attachment
Step Five: Back Assembly