SEASIDE CASUAL FURNITURE Portsmouth Bar Table User manual

1
Tools Required:
Phillip's Head Screwdriver
4MM Allen Wrench (Included)
(51) 42In X 42In Portsmouth Bar Table
WOODENVIRO
SEASIDE CASUAL FURNITURE
Hardware:
(28) 3” Hex 1/4” Lags
(10) 3/4” Pan Head Screws
(2) Thumb Screws
(1) Table Top
Parts List:
Assembly Instructions
Step One: Set Up
READ ENTIRE INSTRUCTIONS BEFORE BEGINNING! Carefully remove contents
from box. Make sure that all parts and hardware are included.
Place Lower Leg Stretcher between Leg Assemblies aligning pre-
drilled holes. Attach using (4) 3” Hex 1/4” Lags. Repeat process for
other Lower Leg Stretcher. (Right Picture)
Step Two: Lower Leg Stretcher Assembly
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
Step Three: Upper Leg Stretcher Assembly
Place Upper Leg Stretcher between Leg Assemblies aligning pre-
drilled holes. Attach using (4) 3” Hex 1/4” Lags. Repeat process for
other Upper Leg Stretcher. (Left Picture)
Instruction Revision: B
(2) Leg Assemblies
(2) Upper Leg Stretchers
(2) Lower Leg Stretchers
(2) Long Aprons
(2) Short Aprons
(1) Mid Umbrella Stretcher
Step Four: Mid Umbrella Stretcher Assembly
Place Mid Umbrella Stretcher between Upper Leg Stretchers aligning
pre-drilled holes. Attach using (4) 3” Hex 1/4” Lags. (Right Picture)

2
Step Five: Long Apron Assembly
Step Six: Short Apron Assembly
Place Short Aprons in between Long Aprons aligning pre-drilled
holes. Attach using (4) 3” Hex 1/4” Lags. (Right Picture)
Place Long Aprons along Leg Assemblies
aligning pre-drilled holes (Left Picture).
Attach using (4) 3” Hex 1/4” Lags.
Step Seven: Base Assembly
Place Table Top face down on a clean flat surface. Place Base As-
sembly upside down on to the Table Top. Center Base Assembly
within the Table Top. Attach using (10) 3/4” Pan Head Screws. (Left
Picture)
Step Eight: Umbrella Securing
If needed Insert (2) Thumb Screws into threaded insert nuts, which are in the Mid Umbrella
Stretcher. This allows for securing of an Umbrella.