SEASIDE CASUAL FURNITURE COASTLINE MONTEREY ADIRONDACK 310 User manual

Page 1
1 PLEASE READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING. Carefully remove contents from box.
Make sure that all parts and hardware are included using the Parts List below.
ASSEMBLY INSTRUCTIONS
COASTLINE MONTEREY ADIRONDACK
310
75mm Connector Bolt (Actual Size)
Part Code:316-1/4-20-75B x 6
60mm Connector Bolt (Actual Size)
Part Code:316-1/4-20-60B x 4
Part Code:4MMALLEN
4mm Allen Wrench (Actual Size)
x 1
Back Assembly
x 1
1/4 Lock Washer (Actual Size)
Part Code:316-1/4LW x 6
1/4 Flat Washer (Actual Size)
Part Code:316-1/4FW x 10
x 6
1/4 Nut (Actual Size)
Part Code:
316-1/4-20N
Part Code:316-8x1-3/4PFDS
1-3/4 Phillips Head Screw (Actual Size)
x 2
x 4
Lock Nut (Actual Size)
Part Code:
316-1/4-20LN
Seat Assembly
x 1
Right & Left Arm Set
x 1
Right & Left Leg Set
x 1

Page 2
Place Back Assembly on top of
mounting surface of Rear Legs
(Part of Seat Assembly). Push
Back Assembly forward until it
meets the last Seat Slat of the
Seat Assembly. Hold Back As-
sembly in place and install (2) 1-
3/4” Phillips Head Screws into pre
-drilled holes on each side of the
Lower Yoke (No pre-drilled holes
on Rear Legs).
Place Arm on top of Front
Leg. Align pre-drilled
holes. Install a 60mm con-
nector bolt, starting from
the Front Leg through the
Underarm. Finger tighten
flat washer and Lock Nut.
Do not fully tighten at this
time. Repeat process for
opposite Arm.
Attach using (3) 75mm
connector bolts through the
pre-drilled holes. Finger tight-
en flat washer, lock washer,
and attach nut on each bolt.
Do not fully tighten at this
time. Repeat process for op-
posite Leg.
2 ATTACH LEGS TO SEAT ASSEMBLY 3 ATTACH ARMS TO TOP O F LEGS
4 ATTACH ARMS TO BACK ASSEMBLY 5 ATTACH BACK ASSEMBLY TO SEAT
ASSEMBLY Phillips Head Screw Driver Required (Not Included)
6 TIGHTEN ALL CONNECTI ONS AVOIDING OVER TIGHTENING; DOING SO CAN CAUSE DAMAGE TO
THE PRODUCT 7/16 Wrench or Socket Required (Not Included) and 4mm Allen Wrench Required (Included)
Place Upper Yoke of the Back
Assembly underneath arms, aligning
pre-drilled holes. Install (1) 60mm
connector bolt through pre-drilled hole
of the Arm and through Upper Yoke.
Finger tighten flat washer and Lock
Nut. Do not fully tighten at this time.
Repeat process for opposite Arm.