SEASIDE CASUAL FURNITURE ENVIRO WOOD 095 User manual

1
Tools Required:
Phillip's Head Screwdriver
4MM Allen Wrench (Included)
(095) 24In X 50In Windsor Buffet Table rev. A
(195) 19In X 36In Windsor Buffet Table rev. A
WOODENVIRO
SEASIDE CASUAL FURNITURE
Hardware:
(8) 3” Hex 1/4” Lags
(4) 1-3/4” Phillip’s Head Screws
(4) 1-1/4” Phillip’s Head Screws
(8) 5/8” Plugs
(12) 3/4” Pan Head Screws -
(095 Only)
Note:
095 Does have Aluminum
195 Dose not have Aluminum.
(1) Table Top
Parts List:
Assembly Instructions
Step One: Set Up
READ ENTIRE INSTRUCTIONS BEFORE BEGINNING! Carefully remove contents
from box. Make sure that all parts and hardware are included.
Step Two: Leg Assembly (095,195)
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
Step Three: Short Apron Attachment (095,195)
Attach Short Apron, which is pre-assembled on Leg Assembly to Ta-
ble Top using (2) 1-3/4” Phillips Head Screws. (Right Picture) Re-
peat process on other side.
!!!WARNING!!! Do not use a Portable Screw Gun. This may cause
screws to go through the Table Top.
Instruction Revision: B
(1) Shelf
(2) Leg Assemblies
Place Table Top face down on a flat clean
surface. Place Leg Assembly upside down
on each side of Table Top aligning pre-
drilled holes and facing the Aluminum
Cleat inside the Table Top (Left Picture).
Attach using (2) 3” Hex 1/4” Lags. Repeat
process on other side. (Right Picture)

2
Tighten all connections. Do not over tighten!!! Over tightening of hardware can cause
damage to the item. Plug all holes using (8) 5/8” Plugs. Don’t force plugs in with anything
that can damage them.
Step Five: Shelf Assembly (095,195)
Step Eight: Tightening of Hardware
Flip Assembly to standing position. Place Shelf Assembly into posi-
tion between the Leg Assemblies resting on top of Lower Shelf
Apron Stretchers aligning pre-drilled holes. Make sure the shelf slats
are resting tightly against the Lower Shelf Apron before securing.
Attach using (2) 3” Hex 1/4” Lags. (Right Picture) Repeat process on
other side.
Step Four: Short Apron Aluminum Attachment (095 Only)
Attach Short Apron Aluminum, which is pre-assembled on Leg As-
sembly to Table Top using (3) 3/4” Pan Head Screws. (Left Picture)
Repeat process on other side.
Step Six: Lower Shelf Apron Attachment (095,195)
Attach Lower Shelf Apron, which is pre-assembled on Leg Assem-
bly to Shelf using (2) 1-1/4” Phillips Head Screws. (Right Picture)
Repeat process on other side.
!!!WARNING!!! Do not use a Portable Screw Gun. This may cause
screws to go through the Shelf.
Step Seven: Lower Shelf Apron Aluminum Attachment (095 Only)
Attach Lower Shelf Apron Aluminum, which is pre-assembled on
Leg Assembly to Shelf using (3) 3/4” Pan Head Screws. (Left Pic-
ture) Repeat process on other side.