SEASIDE CASUAL FURNITURE ENVIRO WOOD Westport Bistro Tables User manual

1
ENVIRO WOOD
SEASIDE CASUAL FURNITURE
(34, 41, 66, 69) 36” Westport Bistro Tables
(34, 66, 69 rev. A) (41 rev. B)
Hardware:
(12) 3/4” Pan Head Screws
(1) Umbrella Reducer
The Following is for
(34,66 Only)
(1) 1-1/4” Phillip’s Head Screw
(2) Thumb Screws
The Following is for (66 & 69
Only)
(4) 1-1/2” Pan Head Screws
Tools Required:
Phillip's Head Screwdriver
4MM Allen Wrench (Included)
(1) Foot Rest
(66 & 69 Only)
(1) Leg Assem-
bly 2
(1) Leg Assem-
bly 1
(1) Table Top
(1) Umbrella
Base Cup
Assembly Instructions
Step One: Set Up
READ ALL INSTRUCTION BEFORE BEGINNING!Carefully remove contents from box.
Make sure that all parts and hardware are included. Assembly of Table may require two people.
Step Two: Leg Assembly
Align the notches in the feet with one another,
may need to be manipulated (Left Picture).
For (66 & 69 Only): Insert Foot Rest in be-
tween the leg assemblies, aligning the notches
in the foot rest with notches in the legs. Make
sure the pockets are facing the feet do not se-
cure at this time (Right Picture).
Step Three: Attaching Leg Assembly
Place Table Top upside down on a clean flat
surface, may use bubble wrap. Flip Base As-
sembly over and align the aluminum in the
notches under the table top, aligning the short
aluminum in the notches under the table top.
Secure using (12) 3/4” pan head screws (Left
Picture).
(66 & 69 Only) Secure foot rest to the legs with
(4) 1-1/2” pan head screws (Right Picture) .
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
Instruction Revision: D

2
Turn assembled table
to standing position.
Place Base Cup in
center of Feet Inter-
section facing up. At-
tach using 1-1/4”
Screws. (Right Pic-
ture)
Step Four: Umbrella Accessories If Needed (34, 66, 69 Only)
Use (2) Thumb Screws
to Secure Umbrella
under Table Top in the
Umbrella Clamp.
(Right Picture)
Use Umbrella Reducer
for 1 to 1-1/2” Um-
brella Poles. (Right
Picture)