Seko Dynamik Time User manual

0000136964
. 1.1
RUS
EN
DYNAMIK TIME
INSTRUCTIONS MANUAL
  

Dynamik Time
: 0000136964 . 1.1
Dynamik Time
 :
:
–
  100 ÷ 240   
 
  (MOM),   (ON),   (OFF)    
  4, 2  1  /  ( 1,5 )     
  24 ÷ 240   
1)   (  MOM / Priming) ”   ,  
”.
2)   (  ON / Run) ” ,   ”
  ””,      A_on
   ””,   ,      Arun
     :
A. Batch Dosing ( ):       
        :
a1.  A ( )  1  60   P ( )  0.
i)   A = 5 P = 0 :     5   , 
  ;
. Cyclic Dosing ( ):   ,    .
b1. 2)  A( ) P( )  1  60 
ii)   = 5 = 8 :    5  ()   8
 (),    ;
3)   (  OFF / Stand-by) ” ”
  Time (),     :
1) A ( -  )  1  60 
2) P ( -  )  0  60 
 Dosing (),    :
A =  4  / 
B =   2  / 
C =  1  / 







Dynamik Time
code: 0000136964 rev. 1.1
Dynamik Time
General Features

Functioning:
1) Pr
iming mode
(Switch position MOM / Priming) “Pump run for all time long that the switch is pressed”
2) Working mode
(Switch position ON /Run) “Wait trigger to start dosing”
Pump waits a “trigger” and the display shows
A_on
flashing
When the pump rec
eives a “trigger”, it start to dose and the display shows
Arun
flashing.
Pump can works in the following two ways:
A. Batch Dosing: the pump starts every time receive the external trigger and work only for the set active time:
a1. set A(activation time) from 1to 60 min and P (pause time) to 0.
i) Example with A= 5and P=0 minutes:
the pump doses for 5minutes every time atrigger comes;
B.
Cyclic Dosing: the pump works cyclically until the trigger is present.
b1. 2) set A(activation time) and P (pause time) from 1to 60 minutes
ii) Example with A= 5and P=8 minutes:
the pump works for 5minutes (ON) and stop for 8minutes (OFF)
until the trigger is present;
3) Programming mode
(Switch position OFF / Stand
-
by) “Pump is stopped”
Press
Time
key to adj
ust dosing time limit:
1)
A
(Active
–
dosing time) from 1to 60 minutes
2)
P
(Pause
–
wait time) from 0to 60 minutes
Press
Dosing
to adjust flow rate pump:
A=Summer 4l/h
B=Middle season 2l/h
C=Winter 1l/h
Customer may use this function to select the
desired dosing amount according to the season or to the period of use of
the swimming pool.
Power Supply 100÷240 Vac
Digital Display
Priming (MOM), Run (ON), Stand-by (OFF) mode selectable by switch
Flow rate 4, 2 and 1 l/h (at 1,5 Bar) selectable by programming menù
External trigger 24÷240 Vac