Cat. No. 003280
K6P
Microphones | Powering Module
General Description
The K6P powering module is at the heart of Sennheiser’s professional
modular condenser microphone system. It is similar to the K6 powering
module but is powered by 12 – 48 V phantom power only, for use where
battery power is not required (e.g. permanent installations). The K6P can
be combined with various microphone heads to produce microphones
with a variety of pick-up patterns. Matt black, anodised, scratch-resis-
tant finish.
Features
j
Switchable bass roll-off filter protects against rumble, handling,
pop and wind noise
j
On/off switch
j
High output, low noise
j
Transformerless balanced output on 3-pin XLR connector
j
Delivery includes: 1 K6P powering module
1 MZQ 200 microphone clamp
1 protective carrying case
Recommended Accessories
j
ME 62 microphone head, omni-directional Cat. No. 003281
j
ME 64 microphone head, cardioid Cat. No. 003282
j
ME 65 microphone head, super-cardioid Cat. No. 003283
j
ME 66 microphone head, short gun Cat. No. 003284
j
ME 67 microphone head, long gun Cat. No. 003285
j
MKE 2-60 Gold-C clip-on microphone, omni-directional Cat. No. 004733
j
ME 102/104/105 mini-modular system
j
MZS 6 shock mount Cat. No. 003287
j
MZQ 6 quick release clamp Cat. No. 003288
Product Variants
j
K6P-C: as K6P, but without accessories Cat. No. 003862
Profile
Powering module for phantom powering with switchable roll-
off filter, suitable for ME 62 – ME 67 microphone heads and
-60 versions of MKE microphones, transmission factor 0 dB at
1 kHz, nominal impedance 200 Ω, min. terminating impedance
1 kΩ, max. output voltage 2 V (at 1 kHz), phantom powering
12 V – 48 V, supply current 2.2 mA, dimensions: Ø 22 x 118 mm,
resultant length 52 mm, weight approx. 30 g.
Technical Data
Frequency response ..................................... 30 – 20,000 Hz - 1 dB
Transmission factor (1 kHz).......................................................0 dB
Nominal impedance ................................................................. 200 Ω
Min. terminating impedance..................................................... 1 kΩ
Max. output voltage................................................... 2 V (at 1 kHz)
Power supply........................................ phantom 12 - 48 V (± 4 V)
Supply current..........................................................................2.2 mA
Dimensions in mm............................................................ 118 x Ø 22
Resultant length in mm* .............................................................. 52
Weight .............................................................................approx. 30 g
* Resultant length: this is the figure you need to add to the microphone head
length to give the overall length of the complete microphone.
Cable pictured is an accessory not supplied with the powering module
