Senonics Minnow Use and care manual

Minnow Logger
Senonics LLC (US & Europe Headquarters) www.senonics.com [email protected] sal[email protected]
Senonics LLC ©
Revision 1.02
Minnow Battery Installation
This document will guide you through installing the battery and then resetting
your logger after a new battery is installed. This reset is needed in order to
set the “real time clock” after a loss of power.
1. Remove the back cover (#1 Philips screwdriver)
2. Remove the circuit board. Place the logger face down and press the edge
of the box to unseat the board and then pry it out using your fingernail.
3. Insert the new battery with the + terminal up and then close the back
cover. Be careful not to over tighten the screws.
4. Download and install the "Minnow Application Program" (Windows only)
from http://senonics.com/support.html
5. Open the application and go to the "Configuration Wizard"
6. Plug the Minnow into the computers USB port
7. The Connection Icon will be blue if connected (be patient the first time)

Minnow Logger
Senonics LLC (US & Europe Headquarters) www.senonics.com [email protected] sal[email protected]
Senonics LLC ©
Revision 1.02
Configuration
Pane Enable
Graphical
Pane Enable Spreadsheet Pane Enable Save Open Celsius/Fahrenheit Connection
Indication Back to front page
Configure
Logger
Read Data
Configuration Pane Graphical Pane Spreadsheet Pane
8. Choose a "Logger Start" option, a "Logging Interval" option and any
alarms if needed.
9. Click "Configure Logger" and you should be ready.
This guide is only for battery install. Refer to User Guide for a detailed set of
instructions.