serene living Hellos S6000 Installation instructions manual

Hellos’ S6000
Infrared
Outdoor Heater
Instructions &
Operation Manual

Safety Information:
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
When using any electrical appliance, safety precautions should always
be observed. Read these instructions carefully, and retain for future
reference.
When used by, or near, young children or infirm persons, supervision is necessary -
young children should be supervised to ensure that they do not play with the appliance.
Use this appliance only with the voltage specified on rating label.
Do NOT use this appliance other than for its intended use.
Do NOT touch hot surfaces or moving parts.
Do NOT cover the grilles or place any object or material up against
the unit, as this may block entry or exhaust of air.
Do NOT probe any opening.
To ensure trouble free performance it is recommended that on a regular basis the unit be
isolated from the power supply and a vacuum cleaner used to remove dust from the inlet
and outlet grilles.
Caution:
When the heater is operated ensure the heater is not obstructed in
any way. Ensure the heater can operate safely, should the heater switch on
when the ambient temperature drops, or a timer activates the heater.
Do NOT allow the supply cord to come into contact with heated
surfaces during operation.
Regulations require that electrical work be carried out by authorised
persons. For your own safety and that of others, ensure this is done.
If the supply cord becomes damaged, it must be replaced by a
qualified person, in order to avoid a hazard

•
•6•7•7
For additional protection the installation of a residual current
device (RCD) is recommended. ( Refer to local electrical
regulations)
Remove all packaging materials and check the appliance, supply cord and the plug (if
fitted) for any signs of damage
Pay attention to the mounting location and the material on to which the heater is
being mounted. Ensure they are suitable and stable enough for mounting and holding
the heater securely in place.
The minimum safe mounting distances and tilt angles shown in the figures
should be strictly followed.
45mm 45mm
45mm
0.2m
0.5m
1.8mm
Installation
•The distance between the bottom edge of the appliance and the floor must be at
least 2.5 M.
•There must be a distance of at least 0.5 M between the appliance and any
ceilings, roofs or other covers. If the covers consist of flammable material, such as
wooden ceilings, wooden roofs etc., the distance at least 1 metre must always
be maintained.
•There must be a distance of at least 1.5 M at each side between the appliance
and walls or the like. See figure 3.
•The max. degree to horizontal is 60°and the min. degree is 40°. See figure 4.
•The infrared heater can also be swung from left to right. The max. swing degree is
25°.
Fix the wall mounting bracket on the wall first. Ensure that the location is secure and
firm.
Assemble the appliance onto the mounting bracket. Adjust the desired angle of
radiation and tighten all screws.
Check regularly the screws’ connection. Mechanical bearing pressure and oscillation
due to wind or rain could loosen screws.
Outdoor heaters should be installed only by a licenced electrician unless
they are connected to an existing approved outdoor waterproof sockets.
ALUMINIUM HEAVY-
DUTY ADJUSTABLE
BRACKETS INC.

Basic Specifications
Model S6000
Voltage (V) 220-240～
Power consumption (W) 2000 watts
Dimensions L 470 X H200 X D126
Weight (kg) 4.6
IP protection IP64
Figure 1: Mounting bracket and
anchor wall plugs provided
Figure 2: Connection from wall
bracket to the infrared heater
Figure 3: Min. distance to
floor, ceiling and wall
1.5M FROM ANY CEILING
CEILING
FLOOR
WALL
Figure 4: Minimal and
maximal tilt angle

Controls - Operation
Hellos’ S6000 is very simple and
safe to operate. Operation is
controlled by the OFF/ON rocker
switch located on the left side of
the unit .
1.To activate the heater the OFF/ON
activation rocker switch must be pushed to
ON position.
2. To turn OFF the heat at any time just
press the waterproof rocker switch to the
OFF position.
Replacing the Heat Tubes
Eventually (normally after several years of
use) a heat tube will need replacing these
can be obtained from any Serene office
worldwide. The tubes should only be
replaced by a qualified electrician.
Waterproof rocker
switch.
Model 6000

Cleaning And Maintenance
This appliance is constructed of a robust and maintenance-free aluminum casing.
There are no user serviceable parts inside.
Before cleaning remove the plug from the power outlet (if fitted) and wait until the
appliance is sufficiently cool.
Wipe the appliance only with clean and lint-free cloth or a soft brush.
Caution! Before the next use the unit must be dry.
Never use abrasive cleaners, scrubbing brushes and chemical cleaners for cleaning!
Never use flammable cleaners such as benzine or spirits.
To protect against electrical shock do not immerse cord, plug, or any part of the
appliance in water or other liquid.
For heating element replacement please contact Serene Industries Limited or a
properly qualified service person.
Recomended Disposal
In accordance with the European Directive 2011/65/EU (not yet mandated in AU and
NZ) concerning used electrical and electronic appliances please return any electrical
equipment that you will no longer use to suitable waste collection points provided for
their disposal.
This symbol indicates that the appliance should not be treated as normal domestic
waste.

Contacts:
HONG KONG
Head Office - Serene Industries Limited
t: [phone]
f: [phone]
e: [e-mail]
w: www.serene-ind.com
Suite 1010, 15F, Block A, Alexander Industrial Building, 62 King Lam
Street, Cheung Sha Wan, Kowloon Hong Kong SAR
NEW ZEALAND
t: (+) 64 (3) 344 5550
f: 0800 437 264- Freefax
e: [e-mail]
w: www.serene-ind.com
PO BOX 33501, Barrington, Christchurch 8024
AUSTRALIA
fp: [phone] Freephone
e: auinquar[email protected]
w: www.serene-ind.com
UNITED KINGDOM and EUROPE
t: [phone]
e: [e-mail]
w: www.serene-ind.com
Unit 2, Royd's Mill Trading Estate, Dyehouse Lane, Brighouse,
West Yorkshire, HD6 1LL