Sharp PN-HS431 User manual

PN-HS431 Dismantle Instruction
1
Dismantle Instruction
LCD MONITOR
MODEL
PN-HS431
701

PN-HS431 Dismantle Instruction
2
Table of contents
1. Scope..................................................................................................................3
2. Tools for dismantling...............................................................................................3
3. Dismantle Procedure ..............................................................................................3
4. Back covers..........................................................................................................4
5. Printed circuit boards .............................................................................................5
6. Battery................................................................................................................5
7. LCD Module ..........................................................................................................6
8. Capacitors............................................................................................................7
9. Parts List .............................................................................................................7

PN-HS431 Dismantle Instruction
3
1. Scope
This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU.
2. Tools for dismantling
Below tools are required to dismantle this product.
- Screw Driver
- Nipper
3. Dismantle Procedure
This product can be dismantled by below steps.
1. Remove Back covers (section 4)
2. Remove Printed circuit boards (section 5)
3. Remove Battery (section 6)
4. Dismantle LCD (section 7)
5. Remove Electrolyte Capacitors (section 8)

PN-HS431 Dismantle Instruction
4
4. Back covers
Back cover can be removed by screw driver.

PN-HS431 Dismantle Instruction
5
5. Printed circuit boards
All PWBs can be removed by screw driver.
Main I/F PWB (1pcs) Power PWB (1pcs)
T-CON PWB (1pcs)
6. Battery
This model uses only AAA battery for remote control.
Battery can easily be removed.

PN-HS431 Dismantle Instruction
6
7. LCD Module
- LCD Dismantle procedure
1. Remove Rear cover
2. Remove PWBs
3. Remove the Cables
LCD

PN-HS431 Dismantle Instruction
7
8. Capacitors
Electrolyte Capacitors which diameter/height is larger than 25mm is installed on Power PWB.
These capacitors can be removed by using nipper to cut the leads.
On Power PWB
9. Parts List
Parts described in Annex VII of directive 2012/19/EU are as below.
Parts
Note
LCD
43inch LCD module
Printed Circuit Boards
Main I/F PWB
Power PWB
T-CON PWB
Battery
AAA battery
Electrolyte capacitors
(height >25mm, diameter >25mm)
On Power PWB
External electric cables
2 kinds of Power Cord
- for EU
- for UK