ShowLed CONBOX User manual

CONBOX Manual
Version-1.0
33
1
1
2
2
get with
t
connect
t
control
t

22
connect
t

Menu Structure 14
User Interface 15
How to set-up the conbox 15
Conbox modes 16-17
DMX Mode- 10 18-21
DMX Mode-24 22
Safety Instrucons 04-05
Introducon 06
Technical Specicaon 07
Typical Product Connecon 08
Control Network Set-up 09-10
Connecng Strings 11-13
FAQ`s 23
Contact & Support Informaon 23
Technical Specicaon 24
Declaraon of Conformity 25
1
get with
t
1
33
t
control
t
22
connect
t
EXTRAS

4
SAFETY INSTRUCTIONS
Take care of environmental limits. Do not exceed them.
(See technical informaon)
The connecon cables are NOT mechanical safees!.
If you are not familiar with mechanical safees, contact us to
provide you with professional advice.
(See contact informaon)
Do not subject to excessive shock by dropping the unit.
Do not expose the conbox to water, rain or direct sunlight.
This conbox is designed and tested for driving LEDs; do not use it
for other purposes.

5
Use only properly grounded power cord and receptacle.
Make sure to read and understand each connecon before
Connecng it.
Make sure that all connecons are made correctly before turning
on conbox.
Always disconnect conbox from the mains supply when connecng
signal leads, the power cord should be connected last.
Do not apply voltage higher than 250Vac to the conbox.
To insure good venlaon in order to prevent re caused by
overheang, do not install or use the conbox in a closed space.
Make sure that the venlaon exits at the sides of the conbox are
not blocked.
Keep minimum distance of 1m between you (or audience) and the
LEDs.
Do not stare in to the LEDs, especially when narrow angle LEDs are
used.
1m

6
ShowLED classic and chameleon star curtains now share the same conbox.
With 8 output channels, a conbox runs a maximum of 512 classic monochrome LEDs or
256 RGB LEDs. With a standard density of around 6 LEDs per sqm (randomly placed),
one conbox can run a starcloth surface of up to 100 sqm for the classic LEDs or 50 sqm
for the RGB version.
By linking several conboxes in master-slave conguraon, mulple panels can become
one extended setup.
On stand-alone mode, choose from twinkling eects, chase paerns, strobe eects, or
see your opons extended to controlling the full colour spectrum once linked to RGB
LEDs.
The conbox oers an eects memory to save your preferred sengs.
The dedicated conbox is DMX compable and oers two DMX modes; control of preset
chases including minimum and maximum intensity, chase speed, and paern
behaviour; or full dimmer control of each individual output channel.
Power Indicator
Menu Buons DMX-in DMX-out Power input
Air Vents - Diagonal Airow (Do not cover)
SD Card Slot
LCD Screen Preview LEDs 16 Connectors
8 RGB Channels
2 Plugs per RGB Channel
INTRODUCTION
1
get with
t
1

7
TECHNICAL INFORMATION
Input
Product specic properes
Control and output characteriscs
Outputs (16 connectors - 2 per output)
Data ports
Environmental
Mechanical
- Supply voltage : 90 ..250Vac
- Stand alone mode with chase paerns
- Interacve operator console
- 12bit dimmer curve (smallest step in dimming is 1/4096)
- LED conguraon with indicator LEDs
- LED outputs protected against short circuit
- RDM ready
- Firmware upgrades possible via SD card
- IDC LED string connectors (No soldering)
Classic mode
Chameleon mode
DIM Value
RED DIM Value
GREEN DIM Value
BLUE DIM Value
DMX input
DMX input
8 bit
8 bit
8 bit
8 bit
Light output
Light output
12 bit
12 bit
12 bit
12 bit
- Output voltage : 5V
- Total output power : 50 Wa
- DMX input
- Dimensions : 140 x 135 x 43 mm
- Weight : 525 g
- DMX output
- Operang temperature, humidity: 00C .. +500C, <80% RH
- Storage temperature, humidity : 00C .. +500C, <60% RH
- Line frequency : 50 ..60 Hz
- Input current : 0.45A (@115 Vac)/0.25A (@230 Vac)
- Input power : 60 Wa
- Fuse : 2.5A (T), 20 x 5 mm
- Mains input : Standardised IEC power inlet
- PFC (Power factor correcon) circuit - present
1
get with
t
1

TYPICAL PRODUCT CONNECTION
STAR CLOTH BACK VIEW
22
connect
t
8
Lining
Monochrome
or
RGB LED Strings
ShowLED Conbox
set to classic or
chameleon

CONTROL NETWORK SET-UP
STAND -ALONE
DUAL MODE
1
1
1
2
2
n
MULTIPLE MODE
For all the above set-ups;
the rst conbox should be set to
‘master’ and all remaining to ‘slave’.
22
connect
t
9

CONTROL NETWORK SET-UP
22
connect
t
10
CONFIGURATIONS WITH A DMX LIGHTING DESK
1
2
n
DMX LIGHTING DESK
In conguraons with use of a DMX lighng desk the rst conbox can either
be set in DMX mode 24 or in DMX mode 10 SYNC.
In DMX mode 24 you can choose if you want to address the conboxes all
together or separately. By seng all the conbox in the control network in DMX
mode 24 on the same DMX base you can address all the conboxes together. By
seng all the conboxes in the control network in DMX mode 24 on a
dierent DMX base (e.g. 1, 25, 49, 73) you can address all the conboxes
separately.
In DMX mode 10 SYNC only the rst conbox in the control network is set on DMX
mode 10 SYNC all the other conboxes are set as slave.
Note that no device can be put aer the slave conbox or aer the master
conbox in this control network, only before the rst conbox!

INTERCONNECTIVITY
CONNECTING STRINGS
22
connect
t
11

CONNECTING STRINGS
22
connect
t
12
POWER OFF CONBOX
POWER ON CONBOX
LEDs on connected string will show
same colour as indicator LEDs on conbox
CONNECT CLASSIC STRINGS
1
1
2
2
3
3
16
16
64 LEDS MAX
PER CHANNEL
1
16 16
16 16
CLASSIC
orange plug

CONNECTING STRINGS
POWER OFF CONBOX
POWER ON CONBOX
RGB LEDs on connected string will show
same colour as indicator LEDs on conbox
22
connect
t
13
CONNECT CHAMELEON STRINGS

3
3
t
control
t
MENU STRUCTURE
14
SET STAND ALONE
SET AS SLAVE SET AS MASTER
EXIT
PATTERN TYPE
PATTERN
BEHAVIOUR
CLASSIC
OUTPUT
CHAMELEON
OUTPUT
AUTO DETECT
SD ACTION
READ SD DIR
(error) (error)
NO VALID FILE
Press to retry
> firmware.bin
Start Upgrade
Updating
Don`t Power Off!
NO SD CARD
MENU BECOMES AVAILABLE AFTER CHOOSING
“CHAMELEON OUTPUT” AS DEVICE FUNCTION
CHASE SPEED
MIN. INTENSITY
MAX. INTENSITY
NUMB. OF
COLOURS
COLOUR 1
COLOUR 2
COLOUR 3
COLOUR 4
SET DMX MODE
DMX 24/8
DMX 10/5
DMX 10/5 SYNC
DEVICE FUNCTION
WWW.SHOWLED.COM
CLV1.1

3
3
t
control
t
USER INTERFACE
HOW TO SETUP THE CONBOX
15
The user interface consists of an LCD display and
keypad with two push buons.
This is the physical interface that lets you access the menu structure.
The menu structure lets you modify the parameters of conbox.
Use the buons (up and down) to scroll through the menu structure.
The up buon lets you scroll up in the menu structure or
increase a parameter.
The down buon lets you scroll down in the menu structure or
decrease parameter.
The up and down buon together lets you select or conrm
a menu buon.
Press RIGHT and LEFT buon together unlock the keypad. Aer unlocking
the conbox,
Choose “ Stand alone” if you don`t want to use a DMX source.
Choose “ DMX mode” if you want to use a DMX source.
Choose “ Device Funcon for operang conbox as classic or chameleon”.

3
3
t
control
t
CONBOX MODES
16
STAND ALONE MODE - SETTING THE PARAMETERS
This Mode is accessible via the menu structure as described on pages. By
using the operator console of conbox, the desired eect can easily be
programmed by seng the following parameters. The parameters need only
be set on the master conbox.
Paern Type: 1 Channel @ maximum intensity
2 Channels @ maximum intensity
3 Channels @ maximum intensity
4 Channels @ maximum intensity
5 Channels @ maximum intensity
6 Channels @ maximum intensity
7 Channels @ maximum intensity
Strobe eect
Paern Behaviour: so chase
hard chase
Chase Speed: 000 (minimum speed)... 255 (maximum speed)
Minimum Intensity: 000... 255
(See also DMX mode 10-fader 4-Minimum Intensity)
Maximum Intensity: 000... 255
(See also DMX mode 10-fader 5 -Maximum Intensity)

3
3
t
control
t
17
Number of Colours: 1 colour
2 colours
3 colours
4 colours
4 colours rotang
3 colours rotang
2 colours rotang
Chameleon!
Colour 1: 000... 255
(See DMX mode 10 - Fader 7 to 10 - Selecon of colour)
Colour 2: 000... 255
(See DMX mode 10 - Fader 7 to 10 - Selecon of colour)
Colour 3: 000... 255
(See DMX mode 10 - Fader 7 to 10 - Selecon of colour)
Colour 4: 000... 255
(See DMX mode 10 - Fader 7 to 10 - Selecon of colour)
Colours 1 to 4 are colour presets in which you can store a colour chosen from
the colour pallet.

3
3
t
control
t
18
DMX MODE 10 - CONTROLLING THE BUILT-IN PATTERNS
If you have more than one conbox, it is advisable to use DMX mode 10
SYNC. The channel descripons DMX Mode 10 have the same meaning as
the parameters in the stand alone mode. Only the means of changing them
are dierent. Instead of using the operator console, the channels (faders) of
the DMX lighng desk are used.
Fader 1 - Paern Type
Fader 2 - Paern Behaviour
With so chase the lights will gradually fade in and out.
With hard chase the light will blink on and o.
Fader 3 - Chase Speed
DMX Value Funcon Descripon
0... 31 Chase Paern 1 1 Channel @ maximum intensity
32... 63 Chase Paern 2 2 Channels @ maximum intensity
64... 91 Chase Paern 3 3 Channels @ maximum intensity
92... 127 Chase Paern 4 4 Channels @ maximum intensity
128... 159 Chase Paern 5 5 Channels @ maximum intensity
160... 191 Chase Paern 6 6 Channels @ maximum intensity
192... 223 Chase Paern 7 7 Channels @ maximum intensity
224... 255 Chase Paern 8 Strobe effect
DMX Value Descripon
0... 127 So chase
128... 255 Hard chase
DMX Value Descripon
0 Minimum speed
...
255 Maximum speed

Fader 4 - Minimum Intensity
Limiter funcon sets the minimum intensity level. When set a value higher
than zero, the LEDs will not dim completely.
Fader 5 - Maximum Intensity
Limiter funcon sets the maximum intensity level. When set to a value lower
than 255, the LEDs will not burn at full capacity.
Note that the maximum intensity has a higher priority than the minimum
intensity!
Fader 6 - Number of colours
3
3
t
control
t
19
DMX Value Descripon
0... 31 1 Colour
32... 63 2 Colours
64... 95 3 Colours
96... 127 4 Colours
160... 191 4 Colours rotang
128... 255 3 Colours rotang
192... 223 2 Colours rotang
224... 255 Chameleon colour change

3
3
t
control
t
20
Fader 7 to 10 - Selecon of colour
Choose from the colour pallet to set the 4 colour presets.
DMX Value Descripon
0 Blue
1... 31 Bluish White
32 White
33... 63 Yellowish White
64 Yellow
65.. 95 Greenish Yellow
96 Green
97... 127 Greenish Cyan
128 Cyan
129... 159 Bluish Cyan
160 Blue
161... 191 Bluish Magenta
192 Magenta
193... 223 Reddish Magenta
224 Red
225... 254 Orange
255 Yellow
0255