Shure R193 User manual

R193
Replacement Cartridge
Shure online user guide for R193 replacement cartridge.
Version: 3.0 (2020-G)

Shure Incorporated
2/7
Table of Contents
R193Replacement Cartridge 3
Installation Guide 3
Certifications 7

Shure Incorporated
3/7
1.
R193
Replacement Cartridge
Installation Guide
Use the following instructions to replace the cartridge in Shure Beta 87 condenser microphones.
Remove the microphone grille by unscrewing it in a counterclockwise direction.

Shure Incorporated
4/7
2.
3.
Using tweezers or small needle-nosed pliers, grasp the pins at the end of the blue and green leads and gently unplug
them from the cartridge.
Be careful when handling the lead wires, as they may easily come loose from the pins.
Remove the old cartridge by pulling off the rubber loops from the three shock-mount posts.

Shure Incorporated
5/7
4.
5.
Attach the pins of the two leads to the sockets in the cartridge base. The green lead matches the center socket and the
blue lead matches the outer socket
Install the new cartridge by slipping the rubber loops over the shock-mount posts.
Align the pin sockets as illustrated below.

Shure Incorporated
6/7

Shure Incorporated
7/7
Once you have installed the cartridge, take care to position the blue end and green lead wires so they do not touch
each other, the cartridge and any other part of the microphone. Otherwise, noise problems may occur.
Certifications
This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: [phone]
Fax: [phone]
Email: [email protected]