Shure SM35 User manual

SM35Performance Headset Condenser Microphone
SM35 Headworn Microphone
The Shure SM35 is a headworn electret condenser microphone, intended for use with a
wireless bodypack transmitter in live stage performances.
Wearing the Microphone
1. Install the windscreen on the microphone boom.
2. Place the headband around the back of the head, with the boom on the left side.
3. Place the microphone at the corner of the mouth. To decrease pops and plosives, avoid
placing the microphone directly in front of the mouth

Note: Do not store the microphone in damp, enclosed spaces. Allow perspiration to dry
completely before storing.
Specifications
Type
Electret Condenser

Frequency Response
40 Hz to 20,000 Hz
Polar Pattern
Unidirectional (Cardioid)
Output Impedance
@ 1 kHz
2400 Ω
Audio Output Level
-59.0 dBV/Pa
Signal-To-Noise Ratio [1]
@ 1 kHz
55 dB
Maximum SPL [1]
1000 Ω load, 1 kHz@ 1%THD
153.0 dB
Dynamic Range [1]
@ 1 kHz, 1000 Ω load
114.0 dB
Equivalent Output Noise [1]
typical, A-Weighted
39 dB
Power Requirements

Connector Type
TA4F XLR connector
+5
V
DC (nominal), 10
V maximum (DC bias)
12 to 52
V
DC, phantom power
Polarity
Positive pressure on diaphragm produces positive voltage on pin 3 with respect to pin 1
Cable
1.1 m (45 in.)
Connector
TA4F or XLR
Net Weight
72 g (2.53 oz.)
[1] Measurements taken using RPM626 preamp
*All specifications measured with a 48 Vdc phantom power supply. The microphone
operates at lower voltages, but with slightly decreased headroom and sensitivity.

Certifications
Note: Testing is based on the use of supplied and recommended cable types. The use of
other than shielded (screened) cable types may degrade EMC performance.
The CE Declaration of Conformity can be obtained
from: www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: [phone]
Fax: [phone]
Email: [email protected]